Honeywell SMV 3000 사용자 설명서
114
SMV 3000 Transmitter User’s Manual
1/99
10.3
Calibrating Analog Output Signal
Background
You can calibrate the transmitter’s analog output circuit at its 0 and 100%
levels by using the transmitter in its constant-current source mode (or
output mode). It is not necessary to remove the transmitter from service
for this procedure.
levels by using the transmitter in its constant-current source mode (or
output mode). It is not necessary to remove the transmitter from service
for this procedure.
Procedure
Depending if you are using the SCT 3000 or the SFC to perform
calibration, refer to the appropriate sections below for the procedure. The
procedure shows you how to calibrate the output signal for a transmitter in
the analog mode. Note that the procedure is similar for a transmitter in the
DE mode, but the SCT (or SFC) must be used to read the output in percent
in place of the milliammeter or voltmeter readings.
calibration, refer to the appropriate sections below for the procedure. The
procedure shows you how to calibrate the output signal for a transmitter in
the analog mode. Note that the procedure is similar for a transmitter in the
DE mode, but the SCT (or SFC) must be used to read the output in percent
in place of the milliammeter or voltmeter readings.
See Figure 28 for a sample test equipment setup.
Using the SCT, select the topic:
Using the SCT, select the topic:
“Calibrating Output at 0 and 100% for an SMV 3000
Transmitter” and Click on “PV4 Output Calibration Form
(FLOW OutCal)” to view the procedure.
Transmitter” and Click on “PV4 Output Calibration Form
(FLOW OutCal)” to view the procedure.
Using the SFC:
Follow the procedure for “Calibrating the Output Signal for
Transmitter in Analog Mode” in Section 7 of the SFC
Operating Guide.
Transmitter in Analog Mode” in Section 7 of the SFC
Operating Guide.