State Industries 185244-004 사용자 설명서

SAFE INSTALLATION, USE AND SERVICE............................2
GENERAL SAFETY..................................................................3
TABLE OF CONTENTS ............................................................4
INTRODUCTION ......................................................................4

Preparing for the New Installation .....................................4

INSTALLATION REQUIREMENTS FOR THE
COMMONWEALTH OF MASSACHUSETTS ...........................5
TYPICAL INSTALLATION ..................................................... 6-7
LOCATING THE NEW WATER HEATER .................................8

Facts to Consider About Location ................................. 8-9

Insulation

Blankets

............................................................9

Combustion Air and Ventilation for Appliances

Located in Unconfi ned Spaces .........................................9

Combustion Air and Ventilation for Appliances

Located in Confi ned Spaces ....................................... 9-10

INSTALLING THE WATER HEATER ......................................11
Water

Piping

..............................................................11-12

Temperature-Pressure Relief Valve ................................12

Gas

Piping

......................................................................13

Sediment

Traps

...............................................................14

Blower

Assembly

Installation

..........................................14

Vent Pipe Connection to Blower Assembly .....................15

Venting and Installation ............................................. 15-16

LIGHTING & OPERATING LABEL .........................................21

TEMPERATURE REGULATION ............................................22
FOR YOUR INFORMATION ...................................................23

Start Up Conditions .........................................................23

Condensate.....................................................................23
Smoke/Odor

....................................................................23

Thermal

Expansion

.........................................................23

Strange

Sounds

..............................................................23

Operational

Conditions

...................................................23

Smelly

Water

...................................................................23

“Air” in Hot Water Faucets ..............................................23

High Temperature Shut Off System ................................23

PERIODIC MAINTENANCE ...................................................24

Venting System Inspection..............................................24

Burner

Inspection

............................................................24

Burner

Cleaning

..............................................................24

Housekeeping

........................................................... 24-25

Anode Rod Inspection.....................................................25

Temperature-Pressure Relief Valve Operation ...............25

Draining...........................................................................25

Drain Valve Washer Replacement ............................ 25-26

Service

............................................................................26

LEAKAGE CHECKPOINTS ....................................................26
REPAIR PARTS ......................................................................27
TROUBLESHOOTING ..................................................... 28-30
WARRANTY ...........................................................................31

Thank You for purchasing this water heater. Properly installed and
maintained, it should give you years of trouble free service.

Abbreviations Found In This Instruction Manual:

• CSA - Canadian Standards Association

• ANSI - American National Standards Institute

• NFPA - National Fire Protection Association

• ASME - American Society of Mechanical Engineers

• GAMA - Gas Appliance Manufacturer’s Association

• UL - Underwriters Laboratories Inc.

This gas-fired water heater is design certified by Underwriters
Laboratories Inc. under American National Standard/CSA Standard for
Gas Water Heaters ANSI Z21.10.1 • CSA 4.1 (current edition).

PREPARING FOR THE INSTALLATION

1. Read the “General Safety” section, page 3 of this manual fi rst and

then the entire manual carefully. If you don’t follow the safety rules,
the water heater will not operate properly. It could cause DEATH,
SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE.

This manual contains instructions for the installation, operation,

and maintenance of the gas-fi red water heater. It also contains
warnings throughout the manual that you must read and be aware
of. All warnings and all instructions are essential to the proper
operation of the water heater and your safety. Since we cannot put
everything on the fi rst few pages, READ THE ENTIRE MANUAL
BEFORE ATTEMPTING TO INSTALL OR OPERATE THE WATER
HEATER.

2. The installation must conform with these instructions and the local

code authority having jurisdiction. In the absence of local codes,
installations shall comply with the National Fuel Gas Code ANSI
Z223.1/NFPA 54 and the National Electrical Code, NFPA 70.
These publications are available from The National Fire Protection
Association, 1 Batterymarch Park, Quincy, MA 02269.

3. The water heater when installed must be grounded in accordance

with the local codes, or in the absence of local codes: In the United
States, the National Electrical Code. ANSI/NFPA 70.

4. If after reading this manual you have any questions or do not

understand any portion of the instructions, call the local gas utility
or the manufacturer whose name appears on the rating plate.

5. Carefully plan the place where you are going to put the water heater.

Correct combustion, vent action, and vent pipe installation are
very important in preventing death from possible carbon monoxide
poisoning and fi res, see Figures 1 and 2.

Examine the location to ensure the water heater complies with the
“Locating the New Water Heater” section in this manual.

6. For California installation this water heater must be braced,

anchored, or strapped to avoid falling or moving during an
earthquake. See instructions for correct installation procedures.
Instructions may be obtained from California Offi ce of the State
Architect, 400 P Street, Sacramento, CA 95814.

7. Massachusetts Code requires this water heater to be installed in

accordance with Massachusetts 248-CMR 2.00: State Plumbing
Code and 248-CMR 5.00. For more information see next page.

8. Complies with SCAQMD rule #1121 and districts having equivalent

NOx requirements.

INTRODUCTION

TABLE OF CONTENTS