3M G5 사용자 설명서
Maintenance
November 6 2014 – Revision 2.1
Page 52 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
XT-1 Headset
Replacing the Ear and Headband Pads
To replace the ear pad, remove the worn/damaged ear pad from the ear cup and
replace it with a new pad.
replace it with a new pad.
Figure 6
To replace the headband pad, remove the worn/damaged pad by peeling it from
the back of the battery housing. Remove protective backing from new pad and
press it into place on the back of the battery housing.
the back of the battery housing. Remove protective backing from new pad and
press it into place on the back of the battery housing.
XT-1 Battery Charger
Location
The battery charger should be placed on a flat surface such as a desktop or table
in a clean, dry environment.
in a clean, dry environment.
Cleaning the Contacts
If the indicators fail to light during charger operation, clean the contacts using a
water–moistened cotton swab.
water–moistened cotton swab.
XT-1 Batteries
Care, Handling and Storage
•
Avoid dropping batteries.
•
Do not carry batteries in your pockets or leave them in hot, damp or
dirty places.
dirty places.
•
Clean the battery contacts periodically using a water–moistened swab.
•
Be careful not to short the battery contacts together.
•
Do not set the batteries contact–side down on a bare metal countertop.
Ear Pad
Headband Pad