Runco CW-95DHD 사용자 설명서
66
CineWall™ Installer/Integrator Manual
PRE
L
Y
• Simple: Select Simple mode from the Color Temp menu (with the CineWall, this is
the only choice) to choose one of three color temperature presets: 3200K, 5500K or
6500K. The default setting, 6500K, is appropriate for most situations. Higher
settings produce a “bluer” picture; lower ones impart a reddish hue to the image.
6500K. The default setting, 6500K, is appropriate for most situations. Higher
settings produce a “bluer” picture; lower ones impart a reddish hue to the image.
(On) or disable (Off) ConstantContrast in the optical engine. ConstantContrast uses a
dynamic iris that modulates light to the DMD based on the actual content of the video
material. Runco recommends that you disable ConstantContrast before adjusting
Brightness, Contrast or other image settings.
dynamic iris that modulates light to the DMD based on the actual content of the video
material. Runco recommends that you disable ConstantContrast before adjusting
Brightness, Contrast or other image settings.
Input Image: The Input Image controls are functionally similar to those in the Picture
menu (refer to page 56), but are accessible only by entering the Calibration menu
passcode.
menu (refer to page 56), but are accessible only by entering the Calibration menu
passcode.
Input Color: The Input Color controls are similar to those in the Display Color menu (see
above), but adjust the color balance of the incoming signal. These settings are also saved
independently for each input and display mode.
above), but adjust the color balance of the incoming signal. These settings are also saved
independently for each input and display mode.
• Gain/Offset (HD1, HD2 and Component/SCART inputs only): These controls
operate similarly to those in the Display Color menu (described on page 64), but affect
the Y, Pb and Pr signal components rather than the red, green and blue channels.
the Y, Pb and Pr signal components rather than the red, green and blue channels.
• Chroma Delay: use the Chroma Delay control to correct a mis-aligned image from a
Composite or S-Video source. Chroma delay in an image causes color shifts to occur
to the left of the vertical edge transitions, producing artificial shadows or a “halo” effect.
If necessary, adjust this setting to eliminate them.
to the left of the vertical edge transitions, producing artificial shadows or a “halo” effect.
If necessary, adjust this setting to eliminate them.
• Noise Filter: To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
Table 5-2. Color Temperature Presets and Associated Color Points
Color Temperature Preset
Associated x/y Values
x
y
3200K
0.423
0.404
5500K
0.332
0.348
6500K
0.313
0.329
The Input Image settings establish the “zero point” for the Picture
menu settings, whose values represent offsets from the Input
Image settings. For example, if you set Brightness to 10 in this
menu, setting Brightness to 10 in the Picture menu results in an
actual setting value of 20 (10+10).
menu settings, whose values represent offsets from the Input
Image settings. For example, if you set Brightness to 10 in this
menu, setting Brightness to 10 in the Picture menu results in an
actual setting value of 20 (10+10).
Note