Uniden D1760 사용자 설명서

There’s a lot of 

noise or static on 

the line 

•  Check for interference from appliances (microwave 

ovens, TVs, etc.) or wireless devices (baby monitors, 

WiFi equipment, etc.). Move the handset or base away 

from the interference source.

•  If you use a telecoil hearing aid, turn on T-coil mode 

(see p. 7).

•  If you have any service that uses the phone line, add a 

DSL or telephone line filter (see below).

No handsets display 

Caller ID information.

•  Let calls ring twice before answering.
•  Make sure your Caller ID service is active.

Caller ID displays briefly 

and then clears.

•  You may have to change the line mode. 

Contact Customer Service for instructions.

I can’t transfer calls.

•  Reset the handset (see p. 16).

Two handsets can’t talk to a caller. •  See if any handset is in Privacy Mode.

A handset says Unavailable.

•  Move the handset closer to the base.

•  See if any handset is in Privacy Mode.

I can’t register a new handset.

•  Reset the handset (see p. 16).

•  See if you have 12 registered handsets.

A telephone line filter or DSL filter prevents services that use the phone line from

causing interference on your phone. To get a line filter, contact your service pro-

vider or look in an electronics store.

Plug the filter into the telephone wall jack and plug the base into the filter. Make a

test call to make sure the noise is gone.

If the liquid is only on the exterior housing of the base or handset, wipe it off and

use as normal. If you can hear liquid inside the housing:

1.  Remove all compartment covers, and disconnect all cables and cords.

2. If liquid is leaking from any vent or hole, turn the phone so that vent faces

down. If not, place the largest vent face down.

3.  Let dry for at least 3 days. Check for liquid inside the phone before replacing

compartment covers & reconnecting cords.