ONKYO DV-SP1000E 사용자 설명서

 

41

 

Connect the IR receiver to the DV-SP1000/
DV-SP1000E as shown below.

 

For another component that is out of range of its remote 
controller, you can use a commercially available IR 
emitter to retransmit the remote controller signals 
received at the DV-SP1000/DV-SP1000E’s IR IN, as 
shown below.

Connect the IR emitter to the DV-SP1000/
DV-SP1000E’s IR OUT, and place the IR emitter in front 
of the other AV component’s remote control sensor (usu-
ally located on its front panel), as shown below. See the 
instructions supplied with the IR emitter.

Only remote controller signals received by the 
DV-SP1000/DV-SP1000E’s IR IN are fed through to the 
IR OUT. Signals picked up by the DV-SP1000/
DV-SP1000E’s remote control sensor are not.

 

• Before connecting the power cord, complete all of the 

necessary audio and video connections.

• Do not use a power cord other than the one supplied 

with the DV-SP1000/DV-SP1000E, which is designed 
exclusively for use with the DV-SP1000/
DV-SP1000E and should not be used with any other 
component.

• Never disconnect the power cord from the 

DV-SP1000/DV-SP1000E while the other end is still 
plugged into a wall outlet. Doing so may cause an 
electric shock. Always disconnect the power cord 
from the wall outlet first.

• The DV-SP1000/DV-SP1000E (not the Canadian 

model) is shipped with the POWER switch in the ON 
position (

). When the power cord is connected for 

the very first time, the DV-SP1000/DV-SP1000E will 
go on standby and the STANDBY indicator will light 
up.

• To completely shutdown the DV-SP1000/

DV-SP1000E, set the POWER switch to the OFF posi-
tion (

). (This does not apply to the Canadian model).

DV-SP1000/DV-SP1000E

from connecting block

Miniplug cable

Signal flow

IR IN

IR OUT

Connecting 
block

IR receiver

DV-SP1000/
DV-SP1000E

IR emitter

Remote controller

Other 
component

Signal flow

Signal flow

DV-SP1000/
DV-SP1000E

Remote control

Other component

sensor

from connecting block

Miniplug cable

Miniplug

IR emitter

IR Emitter

 

The STANDBY indicator lights up.
The STANDBY indicator comes on only if the 
POWER switch is in the ON (

) position. (This 

does not apply to the Canadian model).