John Deere AC-CP3GS 사용자 설명서
16
Centrifugal Pump Operator's Manual
Solutions
Solution 1: Remove debris in impeller. (Do not remove impeller)
Solution 2: Check suction hose. Most cases of lack of priming
or low water flow are caused by air leakage on the suction
side of the pump.
side of the pump.
Suction test:
a. Remove suction hose
b. Start engine with water inside the pump.
c. Press the palm of your hand to cover the suction inlet,
b. Start engine with water inside the pump.
c. Press the palm of your hand to cover the suction inlet,
hold and wait 30 seconds. If you feel suction on your
palm, the pump is working fine. Check suction hose
and connections.
palm, the pump is working fine. Check suction hose
and connections.
d. Check if rubber seal is installed.
Note: In case of water
leakage between
engine and pump,
usually the cause is
damaged mechani-
cal seal. Please ask
shop for assistance
and replace me-
chanical seal.