Sony CDU948S 사용자 설명서

Insert the CD-R drive into computer front as shown, routing cables
accordingly. Secure drive to frame with appropriate screws.

Note:
Slide rails (not included) may be necessary if CD-R drive cannot cannot be
secured. Refer to computer’s User’s Guide for more information.

Locate an available power supply cable, within computer, and connect it to
the rear of CD-R drive as shown.

Note:
The power supply cable connector is designed to fit one way, do not force
it upside down, this could damage drive and void the warranty.

Mounting Screws

Audio Cable

Flat Cable

Hardware Installation      13

5V

+5%

GN

D

PARITY

R GND L

0 1

2

ID SELECT

PREVENT/ALLOW

TEST MODE

INTERFACE CONNECTOR

AUDIO OUT

F.GND

DC INPUT

12V

+10%

-

-

Attach flat SCSI cable to connector at rear of CD-R drive.

Notes:
The 50 pin flat SCSI cable must be firmly attached with its red edge 
(Pin 1) positioned next to the power supply connector. 

If your computer has a Sound Card, an Audio Cable may be connected to
the rear of the CD-R drive.  Contact a local dealer if cable is required.

12     Hardware Installation

5V+5%

GND

DEVICE TYPE

L GND R

0 1

2

ID SELECT

PREVENT/ALLOW

TEST MODE

INTERFACE CONNECTOR

AUDIO OUT

F.GND

DC INPUT

12V+10%

-

-

DEVICE TYP

L GND R

0 1

2

ID SELECT

PREVENT/A

TEST MODE

AUDIO OUT

F.GND

Interface Connector

Pin 1

Power Supply Connector

Red Edge

Audio 
Cable

Audio Out
Connector

Red Wire

SCSI
Flat Cable

CDU948S Drive Unit

5V - 5%

GND

PARITY

2

ID SELECT

PREVENT/ALLOW

TEST MODE

INTERFACE CONNECTOR

DC INPUT

12V - 10%

+

+

Power Supply
Connector

Power Supply Cable