Pioneer CDJ-1000MK3 사용자 설명서

다운로드
페이지 124
2
En <DRB1396>
The exclamation point within an equilateral 
triangle is intended to alert the user to the 
presence of important operating and 
maintenance (servicing) instructions in the 
literature accompanying the appliance. 
The lightning flash with arrowhead symbol, 
within an equilateral triangle, is intended to 
alert the user to the presence of uninsulated 
"dangerous voltage" within the product's 
enclosure that may be of sufficient 
magnitude to constitute a risk of electric 
shock to persons.
CAUTION:
TO PREVENT THE RISK OF ELECTRIC 
SHOCK, DO NOT REMOVE COVER (OR 
BACK).  NO USER-SERVICEABLE PARTS 
INSIDE.  REFER SERVICING TO QUALIFIED 
SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPORTANT
D3-4-2-1-1_En-A
Do not connect either wire to the earth terminal of a 
three pin plug.
NOTE
After replacing or changing a fuse, the fuse cover in 
the plug must be replaced with a fuse cover which 
corresponds to the colour of the insert in the base 
of the plug or the word that is embossed on the 
base of the plug, and the appliance must not be 
used without a fuse cover. If lost replacement fuse 
covers can be  obtained from your dealer. 
Only  5 A  fuses approved by B.S.I or A.S.T.A to 
B.S.1362 should be used. 
  
D3-4-2-1-2-2_En
The wires in this mains lead are coloured in 
accordance with the following code:
 Blue  : 
Neutral
 Brown 
Live
If the plug provided is unsuitable for your socket 
outlets, the plug must be cut off and a suitable plug 
fitted. 
IMPORTANT
FOR USE IN THE UNITED 
KINGDOM
The cut-off plug should be disposed of and must 
not be inserted into any 13 amp socket as this can 
result in electric shock. The plug  or  adaptor or the 
distribution panel should be provided with 5 A fuse.  
As the colours of the wires in the mains lead of this 
appliance may not correspond with coloured 
markings identifying the terminals in your plug, 
proceed as follows ;
The wire which is coloured blue must be connected 
to the terminal which is marked with the letter N or 
coloured black.
The wire which is coloured brown must be 
connected to the terminal which is marked with the 
letter L or coloured red.
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified 
service personnel.
CAUTION
This product is a class 1 laser product, but this 
product contains a laser diode higher than Class 1. 
To ensure continued safety, do not remove any covers 
or attempt to gain access to the inside of the product. 
Refer all servicing to qualified personnel. 
The following caution label appears on your unit.
Location: top of the CD drive
CLASS 1
LASER PRODUCT
D3-4-2-1-8_B_En
CAUTION
ATTENTION
CLASS  3B  INVISIBLE  LASER  RADIATION 
WHEN OPEN,  AVOID   EXPOSURE  TO  BEAM.
RADIATIONS LASER INVISIBLES DE CLASSE 3B QUAND 
OUVERT. ÉVITEZ TOUT EXPOSITION AU FAISCEAU.
ADVARSEL
KLASSE 3B USYNLIG LASERSTRÅLING VED ÅBNING.  
UNDGÅ UDSÆTTELSE FOR STRÅLING.
VARNING
KLASS  3B  OSYNLIG LASERSTRÅLNING NÄR DENNA DEL 
ÄR ÖPPNAD.  UNDVIK  ATT  UTSÄTTA DIG FÖR  STRÅLEN.
VARO!
AVATTAESSA   OLET   ALTTIINA   NÄKYMÄTTÖMÄLLE 
LUOKAN   3B   LASERSÄTEILYLLE.   ÄLÄ   KATSO  SÄTEESEEN.
PRECAUCIAÓN
CUANDO SE ABRE HAY RADIACIÓN  LÁSER  DE  CLASE  3B 
INVISIBLE.  EVITE  LA   EXPOSICIÓN  A  LOS  RAYOS  LÁSER.
VORSICHT
BEI GEÖFFNETER ABDECKUNG IST UNSICHTBARE LASERSTRAHLUNG 
DER KLASSE 3B  IM GERÄTEINNEREN  VORHANDEN. NICHT  DEM  
LASERSTRAHLAUSSETZEN!
DRW2308-A
WARNING
This equipment is not waterproof. To prevent a fire 
or shock hazard, do not place any container filed 
with liquid near this equipment (such as a vase or 
flower pot) or expose it to dripping, splashing, rain 
or moisture.    
D3-4-2-1-3_A_En
WARNING 
The voltage of the available power supply differs 
according to country or region. Be sure that the 
power supply voltage of the area where this unit 
will be used meets the required voltage (e.g., 230V 
or 120V) written on the rear panel. 
D3-4-2-1-4_A_En
Before plugging in for the first time, read the following 
 section carefully.
WARNING
To prevent a fire hazard, do not place any naked 
flame sources (such as a lighted candle) on the 
equipment.    
D3-4-2-1-7a_A_En
VENTILATION CAUTION
When installing this unit, make sure to leave space 
around the unit for ventilation to improve heat 
radiation (at least 5 cm at rear, and 5 cm at each 
side).
WARNING
Slots and openings in the cabinet are provided for 
ventilation to ensure reliable operation of the 
product, and to protect it from overheating. To 
prevent fire hazard, the openings should never be 
blocked or covered with items (such as newspapers, 
table-cloths, curtains) or by operating the 
equipment on thick carpet or a bed. 
D3-4-2-1-7b_A_En
Operating Environment
Operating environment temperature and humidity:
+5 ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH 
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in 
locations exposed to high humidity or direct sunlight (or 
strong artificial light)
 
D3-4-2-1-7c_A_En
This product complies with the Low Voltage Directive 
(73/23/EEC, amended by 93/68/EEC), EMC Directives 
(89/336/EEC, amended by 92/31/EEC and 
93/68/EEC).  
 
 
D3-4-2-1-9a_En
If the AC plug of this unit does not match the AC 
outlet you want to use, the plug must be removed 
and appropriate one fitted. Replacement and 
mounting of an AC plug on the power supply cord of 
this unit should be performed only by qualified 
service personnel. If connected to an AC outlet, the 
cut-off plug can cause severe electrical shock. Make 
sure it is properly disposed of after removal.
The equipment should be disconnected by removing 
the mains plug from the wall socket when left 
unused for a long period of time (for example, when 
on vacation). 
 
 
D3-4-2-2-1a_A_En
CAUTION
The POWER switch on this unit will not completely 
shut off all power from the AC outlet. Since the 
power cord serves as the main disconnect device for 
the unit, you will need to unplug it from the AC outlet 
to shut down all power. Therefore, make sure the 
unit has been installed so that the power cord can 
be easily unplugged from the AC outlet in case of an 
accident. To avoid fire hazard, the power cord should 
also be unplugged from the AC outlet when left 
unused for a long period of time (for example, when 
on vacation).  
 
 
D3-4-2-2-2a_A_En
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the 
plug by tugging the cord and never touch the power 
cord when your hands are wet as this could cause a 
short circuit or electric shock. Do not place the unit, a 
piece of furniture, etc., on the power cord, or pinch the 
cord. Never make a knot in the cord or tie it with other 
cords. The power cords should be routed such that they 
are not likely to be stepped on. A damaged power cord 
can cause a fire or give you an electrical shock. Check 
the power cord once in a while. When you find it 
damaged, ask your nearest PIONEER authorized 
service center or your dealer for a replacement.
 
S002_En
If you want to dispose this product, do not mix it with general
household waste. There is a separate collection system for used
electronic products in accordance with legislation that requires
proper treatment, recovery and recycling.
Private households in the 25 member states of the EU, in Switzerland and
Norway may return their used electronic products free of charge to desig-
nated collection facilities or to a retailer (if you purchase a similar new one).
For countries not mentioned above, please contact your local authorities for
the correct method of disposal.
By doing so you will ensure that your disposed product undergoes the neces-
sary treatment, recovery and recycling and thus prevent potential negative
effects on the environment and human health.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory
drawings. However the method of connecting and operating the unit is the same.
 
K015 En