Sony 3-270-589-12 (1) 사용자 설명서
85
File Operations in File Access Mode (for Macintosh)
Chap
ter
5
5
F
ile Op
er
at
ions
at least 10 seconds, and then reconnect the
disconnected cable.
disconnected cable.
The unit is powered off and an i.LINK cable is
connected: Power the unit on.
To disable FAM connections
Execute one of the procedures described in the previous
section “To make a reconnection” to make a FAM
connection between this unit and the remote computer. To
disable FAM connections, in the setup menu, set
INTERFACE SELECT >i.LINK MODE to “AV/C” (see
page 103).
section “To make a reconnection” to make a FAM
connection between this unit and the remote computer. To
disable FAM connections, in the setup menu, set
INTERFACE SELECT >i.LINK MODE to “AV/C” (see
page 103).
File Operations in File
Access Mode (for
Macintosh)
Access Mode (for
Macintosh)
File access mode operating environment
Operating system requirements for file operations by file
access mode are as follows.
• Computer operating system: Mac OS X v10.4.11 or
access mode are as follows.
• Computer operating system: Mac OS X v10.4.11 or
higher
Preparations
Do the following on the remote computer and this unit.
• Install the FAM driver on the remote computer (see the
Do the following on the remote computer and this unit.
• Install the FAM driver on the remote computer (see the
next item).
To install the FAM driver
Insert the supplied CD-ROM (XDCAM Application) into
the CD-ROM drive of your computer, and execute the
FAM Driver >Mac >FAM Driver 1.1.1.dmg file, then
follow the installation instructions.
Insert the supplied CD-ROM (XDCAM Application) into
the CD-ROM drive of your computer, and execute the
FAM Driver >Mac >FAM Driver 1.1.1.dmg file, then
follow the installation instructions.
For details, refer to the ReadMe file contained on the CD-
ROM disc.
ROM disc.
To check the FAM driver version
Connect this unit to your computer with an i.LINK cable,
and then, with a disc loaded, start the system profiler utility
of the application. The version appears to the right of
“prodisk_fs” when you select “Advanced Functions”
under “Software”.
Connect this unit to your computer with an i.LINK cable,
and then, with a disc loaded, start the system profiler utility
of the application. The version appears to the right of
“prodisk_fs” when you select “Advanced Functions”
under “Software”.
Making FAM Connections
Proceed as follows.
1
If there is a disc loaded in this unit, put the unit into the
following state.
following state.
• Recording, playback, search and other disc
operations: Stopped
• THUMBNAIL button: Off
• Disc access by clip deletion, disc formatting, or
• Disc access by clip deletion, disc formatting, or
other operation: Stopped
• Picture Cache function and Interval Rec function:
Off
• MENU button: OFF
• Unsaved current clip list: Save or clear
• Unsaved current clip list: Save or clear
2
Connect the S400 connector on this unit to the
i.LINK (IEEE1394) connector on the remote
computer, using an i.LINK cable (see page 84).
i.LINK (IEEE1394) connector on the remote
computer, using an i.LINK cable (see page 84).