TANDBERG D5016402 사용자 설명서
Installation
TANDBERG Director Videoconferencing System
26
Network Connections
The network connections are located on the rear interface panel of the TANDBERG 6000 Codec.
The network cables should be connected as applicable to the site. Refer to ‘A
DVANCED
U
SE
’ >
‘T
ERMINAL
S
ETTINGS
’ for more information concerning IP settings and other network equipment
that may be required, such as network terminating units and CSUs.
ISDN BRI
Connect each ISDN cable to the ISDN BRI sockets found on the codec. Then connect the other
end of the loom to the appropriate wall sockets. If however, the wall sockets provide an ISDN U-
interface, the ISDN lines from the codec must first be connected to the S/T interface of network
terminating units NT1 and NT384. Then connect the U interface of the network terminating units to
the wall sockets.
end of the loom to the appropriate wall sockets. If however, the wall sockets provide an ISDN U-
interface, the ISDN lines from the codec must first be connected to the S/T interface of network
terminating units NT1 and NT384. Then connect the U interface of the network terminating units to
the wall sockets.
ISDN PRI/T1
Connect the PRI/T1 cable to the PRI/T1 socket labeled “1” on the codec. Connect the other end of
the cable to a Channel Service Unit (CSU). Then connect the CSU to the site’s PRI/T1 line.
the cable to a Channel Service Unit (CSU). Then connect the CSU to the site’s PRI/T1 line.
Other Networks - Using the External Network Interface
If you are using other networks, please refer to ‘E
XTERNAL
N
ETWORK
S
ETTINGS
’ and ‘A
PPENDIX
2’.
LAN
Connect the LAN cable from the LAN connector on the rear of the codec to the site’s LAN network
connection.
connection.
It is recommended that both the codec and control system be provided with a LAN connection.
The system will function without a LAN connection if you are placing ISDN calls only, but a LAN
connection is recommended for both software upgrades and remote diagnostics. The control
system LAN information must be set locally. For information regarding the network settings on the
codec, refer to ‘A
The system will function without a LAN connection if you are placing ISDN calls only, but a LAN
connection is recommended for both software upgrades and remote diagnostics. The control
system LAN information must be set locally. For information regarding the network settings on the
codec, refer to ‘A
DVANCED
U
SE
’ > ‘T
ERMINAL
S
ETTINGS
’.
N O T E
T
HE
LAN
CONNECTION
ENABLES
YOU
TO
PLACE
IP
CALLS
ONLY
,
SOFTWARE
UPGRADES
AND
REMOTE
DIAGNOSTICS
. ISDN
CALLS
MUST
HAVE
ISDN
CONNECTIONS
CONFIGURED
.
N O T E
B
E
SURE
TO
WRITE
DOWN
THE
NUMBERS
ASSOCIATED
WITH
EACH
OF
THE
ISDN
LINES
. Y
OU
WILL
NEED
THEM
LATER
TO
CONFIGURE
THE
SYSTEM
.