TANDBERG D5016402 사용자 설명서
General Use
TANDBERG Director Videoconferencing System
38
N O T E
I
F
THE
PROJECTOR
IS
ON
STANDBY
,
NO
CALLS
CAN
BE
MADE
OR
RECEIVED
.
Projector Standby Button
Press this button to power on the projector lamp.
When finished, press it to put the projector into reversible standby mode for five minutes. The
screen appears black, but the projector lamp remains on so you can restore the image by pressing
any button on the Control Panel. After five minutes, the lamp begins to power down. After an
additional 90 seconds, full standby mode is reached.
screen appears black, but the projector lamp remains on so you can restore the image by pressing
any button on the Control Panel. After five minutes, the lamp begins to power down. After an
additional 90 seconds, full standby mode is reached.
If you prefer, you can skip the five-minute reversible period: Press and hold the P
ROJECTOR
S
TANDBY
button for a few seconds until you see “Please Wait a Moment” appear on the bottom of
the screen. Release the button and the lamp starts powering down, reaching full standby mode in
90 seconds.
90 seconds.
For the current status of the lamp, check the LED indicator immediately to the left of this button.
The table below correlates the behavior of this LED and the status of the projector lamp.
The table below correlates the behavior of this LED and the status of the projector lamp.
LED Behavior
Blinking
Remains steady green
Blinking very fast
Blinking slowly
Blinking very slowly
Projector Lamp Status
Lamp is powering up
Lamp is on
Lamp is in reversible standby mode
Lamp is powering down
Lamp is off and in full standby mode
N O T E
P
RESSING
THE
GREEN
POWER
BUTTON
WILL
DISCONNECT
ANY
CALLS
ACTIVE
AT
THAT
TIME
.