JVC KD-SH9105 사용자 설명서

30

You can set the speaker output balance,
subwoofer output level, and input level of each
source.

• There is a time limit in doing the following

procedure. If the setting is canceled before you
finish, start from step 

1 again.

Each time you press the button,
the adjustable items change as
follows:

• For DSP mode settings, see pages 25

to 27.

• For iEQ (sound mode) settings, see pages

28 and 29.

Fad

Adjust the front

R06 (Rear only)

and rear speaker

   |

balance.

F06 (Front only)

Bal

Adjust the left

L06 (Left only)

and right speaker    |
balance.

R06 (Right only)

Sub Out

Adjust the

 00 (min.)

subwoofer output

   |

level and cutoff

08 (max.)

frequency level.

Low/Mid/High

Vol Adj

Adjust and store

 –05 (min.)

the input level

   |

of each source.

+05 (max.)

To adjust fader and balance—Fad, Bal:
Make these two adjustments at the same
time.
• If you are using a two-speaker system, set

the fader level to “00.”

• Press 

5 (up) or ∞

(down) to adjust the
fader.

• Press 

¢ 

 or

 

4 to adjust the

balance.

To adjust subwoofer output—Sub Out:
This takes effect only when a subwoofer is
connected.

You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.

• Press 

¢ 

 or 

 

4 to select “Low,”

“Mid,” or “High.”

Low:

Frequencies higher than 50 Hz are
cut off to the subwoofer.

Mid:

Frequencies higher than 80 Hz are
cut off to the subwoofer.

High: Frequencies higher than 115 Hz are

cut off to the subwoofer.

To increase the level.

To decrease the level.

ATT

EN25-31SH9105[U]f.p65

03.3.6, 16:24

30