Marantz CR601 사용자 설명서
9
ENGLISH
CONNECTIONS
CONNECTING SPEAKERS
MODEL NO. CR601
ANTENNA
ANTENNA
R
R
L
L
SPEAKERS
SPEAKERS
OPT
OPT
DIGITAL
DIGITAL
OUT
OUT
R
R
L
L
DVD
DVD
IN
IN
MD
MD
IN
IN
TAPE
TAPE
IN
IN
OUT
OUT
OUT
OUT
L
L
R
R
SUB
SUB
WOOFER
WOOFER
AC IN
AC IN
FM(75
FM(75
Ω
Ω
)
)
GND
GND
AM
AM
DAB
DAB
FRONT SPEAKER
RIGHT LEFT
POWERED
SUBWOOFER
Before you connect your speakers, read the
following:
following:
• Disconnect the mains cord from the wall outlet.
• Read the instructions supplied with your
speakers.
• Pay close attention to speaker wiring polarity. In
other words, connect positive
ª
terminals only
to positive
ª
terminals, and negative
·
terminals only to negative
·
terminals. If you
get them the wrong way around, the sound will
be out of phase and will sound odd.
be out of phase and will sound odd.
• Only use speakers with an impedance of 6 ohms
or higher. If you use speakers with a lower
impedance, and use the amplifier at high volume
levels for a long period of time, the built-in
protection circuit may be activated.
impedance, and use the amplifier at high volume
levels for a long period of time, the built-in
protection circuit may be activated.
• Unnecessarily long or very thin speaker wires
may affect the sound quality and should be
avoided.
avoided.
• Be careful not to short the positive and negative
connections. Doing so may damage the CR601.
• Don’t connect more than one wire to each
speaker terminal. Doing so may damage the
CR601.
CR601.
• If you want to connect a single speaker instead
of a pair, connect it to either the left or right
speaker terminals, not both.
speaker terminals, not both.
7 Connecting a subwoofer
Use the PRE OUT SUBWOOFER jack to connect
a powered subwoofer (the power amplifier is built
in ). If your subwoofer is a passive type (the power
amplifier is not built in), connect a monaural power
amplifier to the PRE OUT SUBWOOFER jack and
connect the subwoofer to the amplifier.
a powered subwoofer (the power amplifier is built
in ). If your subwoofer is a passive type (the power
amplifier is not built in), connect a monaural power
amplifier to the PRE OUT SUBWOOFER jack and
connect the subwoofer to the amplifier.
7 Connecting Speaker Wire
1.
Strip away approx. 10
mm (3/8 inch) of wire
insulation.
mm (3/8 inch) of wire
insulation.
2.
Twist the
bared wire
ends tight, to
prevent short
circuits.
bared wire
ends tight, to
prevent short
circuits.
3.
Push the terminal lever in
the direction of the arrow,
and keep this condition.
the direction of the arrow,
and keep this condition.
4.
Insert the bare part of the
wire into the hole in the
side of each terminal.
wire into the hole in the
side of each terminal.
5.
Put the terminal lever
back, and make sure it is
fastened securely by
pulling the wire lightly.
back, and make sure it is
fastened securely by
pulling the wire lightly.
10 mm (3/8 inch)
CR601N_01 Eng 05.10.21 1:21 PM ページ9