American Standard 7048 전단

다운로드
페이지 2
A
B
Double Bowl
Trap
4
7
8
Connect supply lines to
faucet finger tight, and
carefully bend to engage 
with the supply stops.
Tighten connections to
faucet for secure seal.
Before applying the
sealant, place the sink
temporarily into the
cutout. Check for
alignment and clear-
ance, then trace
around the outside
edge of the sink as
a guide for installation location and application of 
sealant.  Remove sink.              
6
Connect drain assembly
hand tight to check 
alignment. It may be
necessary to cut off part
of the tailpiece (area "A") 
or part of the horizontal
leg of the trap (area "B").
Secure joint for water-
tight assembly.
7 9 0 7 5 3 - 1 0 0   R E V   A
2
Apply a masking tape 
outline 1/8" outside 
traced outline as a 
guide for application 
of silicone
sealant. 
1/8"
Sink
Masking
Tape
Masking
tape
outline
Sink
outline
Cutout
Silicone
Sealant
Apply a generous portion of silicone sealant inside line 
traced on countertop. Carefully lower sink into place 
and press down firmly. Use guidelines for proper 
positioning. Using water to dampen your finger, 
remove excess sealant for a smooth even line.  Apply 
additional sealant if necessary to provide a uniform 
bead from the rim of sink to the masking tape line as 
shown. Carefully remove tape. Dampen finger and run 
it slightly over the sealant to remove any high spots.
If inspection of the Corian Sink of this American Standard product, within ten years after 
its initial purchase, confirms that it is defective in materials or workmanship, American 
Standard will repair or, at its option, exchange the product for a similar model.
This warranty applies only to the original purchaser and installation of these products.  All 
labor and transportation costs or charges incidental to warranty service are to be borne by 
the original consumer-purchaser.
This limited warranty does not apply to local building code compliance.  Since local 
building codes vary considerably, the purchaser of this product should check with a local 
building or plumbing contractor to insure local code compliance before installation.
This warranty shall be void if the product has been fabricated or modified in a manner 
inconsistent with the product as shipped by American-Standard; moved from its initial place 
of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or 
other damages; or if it was not installed in accordance with American Standard's 
instructions.
American Standard's option to repair or exchange the product under this warranty does 
not cover any labor or other costs of removal or installation, nor shall American Standard 
be responsible for any other incidental or consequential damages attributable to a 
product defect or to the repair or exchange of a defective product, all of which are 
expressly excluded from this warranty.
 (Some states or provinces do not allow the 
exclusion or limitation of implied warranties, so this exclusion may not apply to you.)
This warranty gives you specific legal rights. You may have other statutory rights that 
vary from state to state of from province to province, in which case this warranty does not 
affect such statutory rights.
In Canada:                   
American-Standard,          
2480 Stanfield Road,          
Mississauga, Ontario 
Canada L4Y 1S2
Toll free: (800) 387-0369  
In Mexico:                   
Customer Service Manager         
Ideal Standard, S.A. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
AMERICAN STANDARD TEN-YEAR LIMITED WARRANTY
CORIAN
®
 SINK
For residents of the United States,
warranty information may also be
obtained by calling the following
toll free number: (800) 442-1902
Corian
®
 Care & 
Maintenance Tips
Use soapy water or 
ammonia-based cleaner.
 
Wipe with damp cloth; towel dry.
Use an abrasive cleanser and 
a green Scotch-Brite* pad.
Occasionally wipe surface with 
diluted household bleach 
(1 part water/1 part bleach).
Rub with Scotch-Brite* pad alone.
Cleaning
Most dirt 
and stains
Water 
marks
Difficult 
stains
Disinfecting
Maintenance
*Registered trademark of the 3M Company
In the United States:
American Standard Inc.,
P. O. Box 6820
Piscataway, NJ  08855
Attention: Director of  Consumer Affairs