Panasonic VQT3U71A(E) 사용자 설명서

8

Single SHIFT is used to switch the individual material of a 
PGM/A bus crosspoint button, PST/B bus crosspoint button 
or AUX bus crosspoint button from a front material to a rear 
material or vice versa.
Switching between the front material and rear material is 
done using the crosspoint button in which the SHIFT function 
is allocated.
The SHIFT function can be allocated to button No.1 or No.12.

 

 Allocating the SHIFT function
Press the 

x button to light its indicator, and display the 

XPT menu.

Use [F1] to display the XPT Setting sub menu.

Use [F2] to select the button to which the SHIFT 

function is to be allocated using the Shift item.

Button No.12

Button No.1

Function is not allocated.

Use [F3] to select the operation to be performed when 

the [SHIFT] button is pressed using the Shift-Lock item.

The rear material is selected only while the 
[SHIFT] button is pressed.

The front material and rear material are 
switched each time the [SHIFT] button is 
pressed.

 

 To use the materials that have been set in the button 

to which the SHIFT function is allocated, either set the 
SHIFT function off or allocate the SHIFT function to 
another button.

 

 If a rear material has been selected regardless of 

whether the Shift-Lock item is On or Off, both the button 
concerned and the [SHIFT] button will light in amber.
When PGM/PST is selected as the bus mode setting 
or when the bus has been switched by a transition, the 
SHIFT status will also be switched.

 

 If the [SHIFT] button for “Single SHIFT” is pressed when 

the rear materials (13 to 24) have been selected using 
“All SHIFT”, the bus crosspoint buttons concerned will be 
switched to the front materials.

 

 When the crosspoint buttons are held down, the button 

numbers and the names of the input materials assigned 
to the buttons are displayed on the built-in display in the 
form of a list for as long as the crosspoint buttons remain 
held down.

Select the A/B bus system or flip-flop system (PGM/PST 
system) from the setting menu.

Press the 

s button to light its indicator, and display the 

Config menu.

Use [F1] to display the Operate sub menu.

Use [F2], and select the A/B or PGM/PST (flip-flop 

system) using the Bus Mode item.

When the fader lever is at side A, the signals 
selected by the A bus are replaced PGM 
materials.
When the fader lever is at side B, the signals 
selected by the B bus are replaced PGM 
materials.

Using a fl ip-fl op system, the signals selected 
by the A bus are always replaced PGM 
materials, and the signals selected by the 
B bus are always replaced PST materials.

Using a fl ip-fl op system, the signals selected 
by the B bus are always replaced PGM 
materials, and the signals selected by the 
A bus are always replaced PST materials.

Select the transition mode using the MIX and WIPE buttons.

Press the [BKGD] button in the transition area so that its 

indicator lights in amber. 
When the [BKGD] button and [KEY] button are pressed 
at the same time, both buttons are selected.

Use the [MIX] and [WIPE] buttons in the transition area 

to select the background transition mode. 
The indicator of the selected button lights in amber.