Sony TC-TX5 사용자 설명서

TC-TX5    3-858-049-11 (1).EN

Before operating the tape deck, check that the
operating voltage of your tape deck is identical with
the voltage of your local power supply.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the
wall outlet, even if the unit itself has been turned
off.

• Unplug the tape deck from the wall outlet (mains)

if it is not to be used for an extended period of
time.  To disconnect the cord (mains lead), pull it
out by the plug.  Never pull the cord itself.

• Should any solid object or liquid fall into the

component, unplug the tape deck and have it
checked by qualified personnel before operating it
any further.

• The mains lead must be changed only at a

qualified service shop.

• Place the tape deck in a location with adequate

ventilation to prevent heat build-up in the tape
deck.

• Do not place the unit in an inclined position.
• Do not place the unit in locations where it is:

— Extremely hot or cold
— Dusty or dirty
— Very humid
— Vibrating
— Subject to direct sunlight

Take up any slack in the tape.  Otherwise the tape
may get entangled in the parts of the tape deck and
become damaged.

The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding etc.
frequently.  The tape may get entangled in the tape
deck.

To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated. If you later want to reuse the tape for
recording, cover the broken tab with adhesive tape.

When you are using a TYPE II (CrO2) or TYPE IV
(metal) cassette, be careful not to cover the detector
slots which allow the tape player to automatically
detect the type of tape.

Clean the tape heads after every 10 hours of use.
When the tape heads become dirty

— the sound is distorted
— there is a decrease in sound level
— the sound drops out
— the tape does not erase completely
— the tape does not record.

Make sure to clean the tape heads before you start
an important recording or after playing an old tape.
Use a separately sold dry-type or wet-type cleaning
cassette.  For details, refer to the instructions of the
cleaning cassette.

Demagnetize the tape heads and the metal parts that
has contact with the tape after every 20 to 30 hours
of use with a separately sold demagnetizing
cassette.  For details, refer to the instructions of the
demagnetizing cassette.

Use a soft cloth slightly moistened with mild
detergent solution.
Never use strong solvents, such as thinner or
benzine, since they may damage the finish.

If you have any questions or problems concerning
your tape deck, please consult your nearest Sony
dealer.

Tab of
side A

Side A

Tab of
side B

TYPE II       TYPE IV

Detector slots