RCA SCT-560 사용자 설명서

10

You can record from any component connected to the
receiver/amplifier or dub (copy) cassette tapes.

Notes:

• Tape quality greatly affects the quality of the

recording. Your cassette deck can play Type I, Type
II, and Type IV tape. We recommend Radio Shack
brand tapes.

• Before recording or dubbing, be sure the cassettes

onto which you want to record or dub have their
erase-protection tabs in place. To prevent
accidental erasure of a tape, remove the erase-
protection tabs. For more information, see “Erase-
Protection Tabs.”

• To record at the beginning of a cassette, turn the

cassette’s hub with your finger or a pencil until the
dark part of the tape enters the opening in the
edge of the cassette. Before dubbing, position both
tapes this way to prevent missing recording
material at the very beginning of a tape.

To record from the device connected to the cassette deck’s

 jacks, follow these steps.

1. Press 

 to turn on the cassette deck.

2. Load a blank tape (or one you want to record

over) into Deck 2. Be sure the side you want
to record on is facing you and the full reel is
to the left.

3. Press 

3 on Deck 2 to set the tape direction

and then press 

7 .

4. Set 

 for the noise-reduction system

you want to use. See “Dolby Noise Reduction”
on Page 7.

5. Set 

. See “Loading and Playing a

Cassette Tape.”

6. Press 

(

¶). The cassette deck enters

the record pause mode.

7. Play the loudest part of the selection you want

to record.

Set 

 so the 

 meter goes to -3 dB

most of the time and to 0 dB at peaks. This gives the
recording a high signal-to-noise ratio with minimum
distortion.

8. Start the source you want to record, then press

3 on Deck 2 to begin recording.

9. To stop recording, press 

7 on Deck 2.

PRB1200A.En.01.13.DOC

9/2/99, 9:18 PM

10