RCA SCT-560 사용자 설명서

6

Loading a Cassette Tape
1. Use your finger or a pencil to turn the

cassette’shub and take up any tape slack.

Note: Avoid touching the tape. Fingerprints attract dirt.

2. Press the appropriate 

EJECT (

0)

 button

(Deck1 or Deck 2) to open the cassette
compartment door.

3. Load the cassette with its open edge down.

Since the decks play in either direction, it does
not matter which side faces out.

4. Gently close the compartment door.

Playing a Cassette Tape
1. Turn on the cassette deck by pressing 

.

2. Load a tape.
3. Set 

 to the setting used when the

tape was recorded. See “Dolby Noise
Reduction.”

4. Set 

 for one-side, two-side, or

continuous two-side play.

“ The cassette deck  plays or records one side of the

tape and stops.

[ The cassette deck plays or records both sides of

the tape and stops.

Note: To play or record both sides, you must press 

3 (not 2).

” The cassette deck plays the tape up to eight times

(16 sides) and stops.

Note: During recording, this setting is the same as one-
side play.See “Using Relay Play” for more details about

.

5. Set the receiver/amplifier’s volume to its lowest

position.

6. Press 

3 on the appropriate deck to play the

side facing you. Press to play the side facing
away from you.

7. Adjust the receiver/amplifier’s volume, tone,

and balance.

8. Press 

STOP (

7)

 to stop playback.

9. Press 

EJECT (

0)

 to open the cassette door

and remove the cassette.

10. To turn off the cassette deck, press 

.

Only the 

 indicator lights.

PRB1200A.En.01.13.DOC

9/2/99, 9:18 PM

6