Eureka 960 사용자 설명서

다운로드
페이지 12
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized outlet only one way. If the plug does
not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way.
Afin de réduire le risque de choc électrique, cet appareil est muni d’une fiche polarisée
(une des lames est plus large). Cette fiche ne peut être insérée dans une prise polarisée
que d’une seule façon. Si la fiche ne peut être insérée dans la prise, retourner la fiche.
Si la fiche ne peut toujours pas être insérée dans la prise, faire installer une prise adéquate
par un électricien qualifié. Ne pas modifier la fiche.
GENERAL INFORMATION
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or
sharp objects with the cleaner to avoid bag breakage, hose clogging, or possible
motor damage.
Service Information
The instructions in this booklet serve as a guide to routine maintenance. For additional
service information telephone our toll free number for the nearest Eureka Authorized
Warranty Station. You should know the model, type and serial numbers when you
call:
USA:  1-800-282-2886
Mexico:  5670-6169
Canada:  1-800-282-2886
If you prefer, you can write to The Eureka Company, Service Division, 807 North Main
Street, Bloomington, Illinois 61701, USA. In Canada write to The Eureka Company, 866
Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka Warranty for complete
service information.
DO NOT OIL the motor at any time. The bearings are permanently
lubricated and sealed.
Rating Plate
The model, type, and serial numbers are
indicated on the rating plate located on the
under side of the cleaner. For prompt and
complete service information, always refer to
these numbers when inquiring about service.
Model & Type______________________ Serial No. _________________________
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects the cleaner in case of
motor overheating. If the cleaner suddenly shuts off, push the on/off button once and
unplug the cleaner. Check the cleaner for a possible source of overheating such as a
full bag, a blocked hose or clogged filter. If these conditions are found, fix them and
wait at least 30 minutes before attempting to use the cleaner. After the 30 minute
period, plug the cleaner back in and push the on/off button to start the cleaner. If the
cleaner still does not run, then take it to a Eureka Authorized Service Center for
repair.
4
THE EUREKA COMPANY
BLOOMINGTON, ILLINOIS 61701
MODEL               TYPE               SERIAL NO.
VOLTS                    AMPS.                     HERTZ
SERVICE INFORMATION: 1-800-282-2886