Yamaha R-S500BL 사용자 설명서

9 PRESET j / i 
Selects a preset FM/AM station when TUNER is selected 
as the input source (see page 24).
Selects a preset SIRIUS channel when SIRIUS is selected 
as the input source (see page 31).

0 FM/CATEGORY l, AM/CATEGORY h 
Sets the FM/AM tuner band to FM or AM when TUNER 
is selected as the input source (see page 20).
Selects a channel category when SIRIUS is selected as the 
input source (see page 29).

A TUNING/CH jj / ii 
Selects the tuning frequency when TUNER is selected as 
the input source (see page 20).
Searches for a SIRIUS channel when SIRIUS is selected 
as the input source (see page 29).

B Remote control sensor
Receives infrared signals from the remote control.

Switch the remote control ID between ID1 and ID2 when using 
multiple Yamaha receivers or amplifiers (see page 44).

C ZONE 2
Turns on Zone 2 or sets ZONE 2 to standby mode. When 
Zone 2 is turned on, signals are output to the ZONE 2 
OUT jacks (see page 45).

D ZONE 2 CONTROL
Allows buttons and controls on the front panel to be used 
to control Zone 2. For more information about controlling 
Zone 2, see page 46.

E CD DIRECT AMP and indicator (R-S700 only)
Allows you to listen to a CD source in the purest possible 
sound (see page 17). The indicator lights up and the front 
panel display turns off when this function is turned on.

• If both the CD DIRECT AMP and the PURE DIRECT are 

turned on, only the CD DIRECT AMP will function.

• Zone 2 cannot be used while this function is turned on.

F PURE DIRECT and indicator
Allows you to listen to a source in the purest possible 
sound (see page 17). The indicator above it lights up and 
the front panel display turns off when this function is 
turned on.

Zone 2 cannot be used while this function is turned on.

G PHONES jack
Outputs audio to your headphones for private listening.

Press SPEAKER A/B so that the SP A/B indicators turn off 
before you connect your headphones to the PHONES jack.

H REC OUT selector
Selects a source for recording to a CD recorder or to a tape 
deck independently of the INPUT selector setting, 
allowing you to record the selected source while listening 
to another source (see page 19).

I BASS control
Increases or decreases the low frequency response. The 
center position produces a flat response (see page 18).

J TREBLE control
Increases or decreases the high frequency response. The 
center position produces a flat response (see page 18).

K BALANCE control
Adjusts the sound output balance of the left and right 
speakers to compensate for sound imbalances caused by 
speaker locations or listening room conditions (see page 
18).

L LOUDNESS control
Retains a full tonal range at any volume level to 
compensate for the human ears’ loss of sensitivity to high 
and low-frequency ranges at a low volume level (see page 
18).

M INPUT selector 
Selects the input source you want to listen to.

N VOLUME control (

Increases or decreases the sound output level.

This does not affect the output level of the REC jacks.