JVC RX-D412BUJ 사용자 설명서

FM/AM tuner
operations

NOTE

When you have selected “FM” or “AM” by using SOURCE SELECTOR
on the front panel, the remote control may not work for tuner
operations. To use the remote control for tuner operations, select
“FM” or “AM” by using the FM/AM button on the remote control.

FM/AM tuner operations are mainly done from the remote
control.

Tuning in to stations manually

From the remote control ONLY:

Press FM/AM to select the band.

The last received station of the selected band is tuned in.
• Each time you press the button, the band alternates

between “FM” and “AM.”

Press repeatedly or hold TUNING

9 or

( TUNING until the station you want is
tuned in.

• Pressing (or holding) TUNING

9 increases the

frequency.

• Pressing (or holding)

( TUNING decreases the

frequency.

NOTES

• When you hold and release TUNING

9 or ( TUNING, the

frequency keeps changing until a station is tuned in.

• When a station of sufficient signal strength is tuned in, the TUNED

indicator lights up on the display.

• When an FM stereo program is received, the STEREO indicator also

lights up.

Using preset tuning

Once a channel number is assigned to a station, the station
can be quickly tuned in by selecting the number. You can
preset up to 30 FM and 15 AM stations.

7 To store the preset stations

Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step

again.

From the remote control ONLY:

Tune in to the station you want to preset

(see “Tuning in to stations manually”
above).

• If you want to store the FM reception mode for this

station, select the FM reception mode you want. See
“Selecting the FM reception mode” on page 25.

Press MEMORY.

The channel number position starts flashing on the display
for about 5 seconds.

24-28_Radio.indd 24

06.6.27 2:41:37 PM