JVC RX-558RBK 사용자 설명서

English

Turn the loop until you have the best reception.

Notes:

• Make sure the antenna conductors do not touch any other

terminals, connecting cords and power cord. This could cause poor
reception.

• If reception is poor, connect an outdoor single vinyl-covered wire to

the AM EXT terminal. (Keep the AM (MW/LW) loop antenna
connected.)

Connecting the Speakers

You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to

emphasize human voices).

• One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting
information properly to obtain the best possible DSP effect. For
details, see page 11.

For each speaker (except for a subwoofer), connect the (–) and (+)
terminals on the rear panel to the (–) and (+) terminals marked on
the speakers. For connecting a subwoofer, see page 5.

AM (MW/LW) Antenna Connections

AM (MW/LW) Loop Antenna

Snap the tabs on the loop into the
slots of the base to assemble the
AM (MW/LW) loop.

Basic connecting procedure

1 Cut, twist and remove the insulation at the end of

each speaker signal cable.

2 Open the terminal and then insert the speaker

signal cable.

3 Close the terminal.

Connecting the front speakers

You can connect two pairs of front speakers (one pair to the FRONT
SPEAKERS

1 terminals, and another pair to the FRONT

SPEAKERS

2 terminals).

FRONT SPEAKERS

Left speaker

Right speaker

FRONT SPEAKERS

Left speaker

Right speaker

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.

Outdoor single vinyl-covered wire

RIGHT

LEFT

FRONT SPEAKERS

ANTENNA

EXT

LOOP

FM 75
COAXIAL

EN01-07.RX-558R[E]/1

99.1.28, 8:37 PM