ONKYO TX-L55 사용자 설명서
16
Connecting Speakers
Before you connect your speakers, read the following:
• Disconnect the power cord from the wall outlet.
• Read the instructions supplied with your speakers.
• Pay close attention to speaker wiring polarity. In other
• Disconnect the power cord from the wall outlet.
• Read the instructions supplied with your speakers.
• Pay close attention to speaker wiring polarity. In other
words, connect positive (+) terminals only to positive
(+) terminals, and negative (–) terminals only to nega-
tive (–) terminals. If you get them the wrong way
around, the sound will be out of phase and will sound
odd.
(+) terminals, and negative (–) terminals only to nega-
tive (–) terminals. If you get them the wrong way
around, the sound will be out of phase and will sound
odd.
• Only use speakers with an impedance of between 6
and 16 ohms. If you use speakers with a lower imped-
ance, and use the amplifier at high volume levels for a
long period of time, the built-in protection circuit may
be activated.
ance, and use the amplifier at high volume levels for a
long period of time, the built-in protection circuit may
be activated.
• Unnecessarily long or very thin speaker cables may
affect the sound quality and should be avoided.
• Be careful not to short the posi-
tive and negative connections.
Doing so may damage the
TX-L55.
Doing so may damage the
TX-L55.
• Don’t connect more than one
cable to each speaker terminal.
Doing so may damage the
TX-L55.
Doing so may damage the
TX-L55.
• If you want to connect a single speaker instead of a
pair, connect it to either the left or right speaker termi-
nals, not both.
nals, not both.
Attaching the Speaker Labels
The TX-L55’s positive (+) speaker terminals are color-
coded for ease of identification. (The negative (–)
speaker terminals are all black.)
coded for ease of identification. (The negative (–)
speaker terminals are all black.)
The supplied speaker labels are also color-coded and you
should attach them to the positive (+) side of each
speaker cable in accordance with the above table.
should attach them to the positive (+) side of each
speaker cable in accordance with the above table.
Connecting the Front Speaker Cables
Connecting the Other Speaker Cables
Maker sure that the speaker connectors are gripping the
bare wires, not the insulation.
bare wires, not the insulation.
Connecting Speakers
Speaker terminal
Color
Front left
White
Front right
Red
Center
Green
Surround left
Blue
Surround right
Gray
Surround back
Brown
R
L
R
L
1
Strip 5/8" (15 mm) of
insulation from the
ends of the speaker
cables, and twist the
bare wires tightly, as
shown.
insulation from the
ends of the speaker
cables, and twist the
bare wires tightly, as
shown.
2
Unscrew the terminal. Fully insert the bare
wires. Screw the terminal tight.
wires. Screw the terminal tight.
1
Strip 3/8" (10 mm) of
insulation from the
ends of the speaker
cables, and twist the
bare wires tightly.
insulation from the
ends of the speaker
cables, and twist the
bare wires tightly.
2
While pushing the lever,
insert the wire into the
hole, and then release the
lever.
insert the wire into the
hole, and then release the
lever.
5/8" (15 mm)
3/8" (10 mm)
TX-L55_En.book Page 16 Tuesday, June 1, 2004 9:02 AM