ONKYO TX-NR5007 사용자 설명서
134
If you’ve connected your Zone 2/3 speakers to the AV
receiver, as explained in “Connecting Your Zone 2
Speakers Directly to the AV receiver” on page 131 or
“Connecting Your Zone 3 Speakers Directly to the AV
receiver” on page 133, you must set the “Powered
Zone2” or “Powered Zone3” setting to “Act” (Acti-
vated).
receiver, as explained in “Connecting Your Zone 2
Speakers Directly to the AV receiver” on page 131 or
“Connecting Your Zone 3 Speakers Directly to the AV
receiver” on page 133, you must set the “Powered
Zone2” or “Powered Zone3” setting to “Act” (Acti-
vated).
Notes:
• Powered Zone2 cannot be used if “Speakers
• Powered Zone2 cannot be used if “Speakers
Type(FrontB)” setting set to “Normal”, “Bi-Amp” or
“BTL” (see page 58).
“BTL” (see page 58).
• Powered Zone3 cannot be used if “Speakers
Type(FrontA)” or “Speakers Type(FrontB)” setting
set to “Bi-Amp” or “BTL” (see page 58).
set to “Bi-Amp” or “BTL” (see page 58).
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
and [ENTER] button.
Setting the Powered Zone 2/3
1
Press the [RECEIVER] button
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
q]/[w]
buttons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [
q]/[w]
buttons to select “1. Speaker
Settings”, and then press
[ENTER].
The “Speaker Settings” menu appears.
Settings”, and then press
[ENTER].
The “Speaker Settings” menu appears.
2. Speaker
Setup
1. Speaker
Settings
2. Speaker
Configuration
3. Speaker
Distance
4. Level
Calibration
5. Equalizer
Settings
6. THX Audio Setup
2–1. Speaker
Settings
Speaker Impedance
Speakers Type(FrontA)
Speakers Type(FrontB)
Powered Zone2
Powered Zone3
Speakers Type(FrontA)
Speakers Type(FrontB)
Powered Zone2
Powered Zone3
6ohms
Normal
Not Use
Not Act
Not Act
Not Act
4
Use the Up and Down [
q]/[w]
buttons to select “Powered
Zone2” or “Powered Zone3”, and
use the Left and Right [
Zone2” or “Powered Zone3”, and
use the Left and Right [
e]/[r]
buttons to select:
Not Act:
ZONE 2/3 L/R speaker terminals
not activated (Powered Zone 2/3
disabled).
not activated (Powered Zone 2/3
disabled).
Act:
ZONE 2/3 L/R speaker terminals
activated (Powered Zone 2/3
enabled).
activated (Powered Zone 2/3
enabled).
5
Press the [SETUP] button.
The setup menu closes.
The setup menu closes.