ONKYO TXNR727 사용자 설명서

You can display various information about the current 
input source as follows.

The following information can be typically displayed.

*1

When AM or FM radio is used, the band, preset number, 
and frequency are displayed. 

*2

If the input signal is digital, the signal format is displayed. 
Information is displayed for about three seconds, then 
the previously displayed information reappears.

With the sleep timer, you can set the AV receiver to 
turn off automatically after a specified period.

You can adjust the brightness of the AV receiver’s 
display, and switch the MASTER VOLUME indicator 
off and on in conjunction.

• Alternatively, you can use DISPLAY on the AV 

receiver.

Sampling

frequency

Input source &

volume

Signal format

Listening mode

Input signal

resolution

Output resolution

Press RECEIVER once followed by SLEEP 
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes 
in 10 minute steps.
The SLEEP indicator lights on the AV receiver’s 
display when the sleep timer has been set. The 
specified sleep time appears for about 5 
seconds, then the previous display reappears.

• If you need to cancel the sleep timer, press SLEEP 

repeatedly until the SLEEP indicator goes off.

• To check the time remaining until the AV receiver 

sleeps, press SLEEP. Note that if you press again on 
SLEEP as the time being displayed is 10 minutes or 
less, the sleep timer will go off.

Press RECEIVER once followed by DIMMER 
repeatedly to cycle through the following 
patterns:
• Normal brightness + indicator off.
• Dim brightness + indicator off.
• Dimmer brightness + indicator off.
• Normal brightness + indicator on (default).

• (North American and Taiwanese models) 

Alternatively, you can use DIMMER on the AV 
receiver.