ONKYO TXNR727 사용자 설명서

■

• The Whole House Mode function shares the input source of 

main room with Multi Zone (

).

■

To control Zone 2/3, you must press ZONE2 or 
ZONE3 on the remote controller first.

■

■

If your Zone 2 speakers are connected to a receiver 
or integrated amplifier in Zone 2, use its volume 
control to adjust the volume.

■

• To unmute, press ZONE2 followed by MUTING again. 

Zone can also be unmuted by adjusting the volume.

• Only analog, NET or USB input source is output from the 

ZONE 2/ZONE 3 LINE OUT jacks and ZONE 2 L/R 
terminals.

• You cannot select different AM or FM radio stations for your 

main room and Zone 2/3. The same AM/FM radio station 
will be heard in each room. Namely, if you have selected an 
FM station for the main room, that station will also be output 
in Zone 2/3.

• You cannot select different input selector NET or USB for 

your main room and Zone 2/3. Namely, if you have selected 
USB input selector for Zone 2/3, USB input selector will be 
selected in main room even if NET has been selected for 
main room.

• BLUETOOTH cannot be selected as input selector in Multi 

Zone. If you play audio from Bluetooth-enabled device in 
Multi Zone, select “Z2 Sel: Source” or “Z3 Sel: Source”, 
and BLUETOOTH as input selector in Main room.

• When Zone 2/3 is activated and its input selector is 

selected, the power consumption of standby mode slightly 
increases.

• While Zone 2/3 is on, 

u functions will not work.

• When setting the AV receiver to standby mode while Zone 

2/3 is active, the Z2 or Z3 indicator is dimly lit.

• Activating Zones in the main room when the listening mode 

is set to Pure Audio (European, Australian and Asian 
models) will automatically switch it to Direct.

• “AUX” cannot be selected as input sources for Zone 2/3.
• When “AUX” is the input source of Main room and Zone 2/3 

is set to share the same source, no sound will be output 
from Zone 2/3.

To turn on Zone 2/3 and select an input source, 
press ZONE 2 or ZONE 3 followed by an input 
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on 
the AV receiver’s display.

To select the same source as the main room’s, 
press ZONE 2 or ZONE 3 twice. “Z2 Sel: 
Source” or “Z3 Sel: Source” appears on the AV 
receiver’s display.

8ON/STANDBY within 8 seconds.

The zone is turned off.

8ON/STANDBY 

Input selector buttons

Press ZONE2 or ZONE3, then point the remote 
controller at the AV receiver and press 
8RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on 
the AV receiver’s display.

8RECEIVER.

The zone is turned off.

q/w.

8RECEIVER 

q/w