ONKYO HT-RC460 사용자 설명서

Here you can check the settings made by Audyssey 2EQ 
Room Correction and Speaker Setup function, or set them 
manually, which is useful if you change one of the 
connected speakers after using Audyssey 2EQ Room 
Correction and Speaker Setup function.

If you bi-amp the front speakers, you must change the 
“Speakers Type (Front)” setting. For details on speaker 
wire connection, see “Bi-amping the Front Speakers” 
(

• When bi-amping is used, the AV receiver is able to drive up to 5.1 

speakers in the main room.

• Before you change these settings, turn down the volume.

■

`

Normal:

Select this if you’ve connected your front speakers 
normally.

`

Bi-Amp:

Select this if you’ve bi-amped your front speakers.

■

`

`

Yes:

Zone 2 speakers can be used. (Powered Zone 2 
enabled).

• If the “Speakers Type (Front)” setting is set to “Bi-Amp”, 

Powered Zone 2 cannot be used.

• When the “Powered Zone 2” setting is set to “Yes” and Zone 2 

is turned on, the surround back and front high speakers cannot be 
used.

With these settings, you can specify which speakers are 
connected and a crossover frequency for each speaker. 
Specify “Full Band” for speakers that can output low 
frequency bass sounds adequately, for example, speakers 
with a good sized woofer. For smaller speakers, specify a 
crossover frequency. Sounds below the crossover 
frequency will be output by the subwoofer instead of the 
speaker. Refer to your speaker’s manuals to determine the 
optimum crossover frequencies.

■

`

`

■

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

• If the “Subwoofer” setting is set to “No”, the “Front” setting is 

fixed at “Full Band”.

■

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`

■

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`

■

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`

*1

“Full Band” can be selected only when “Full Band” is 
selected in the “Front” setting.

*2

If the “Surround” setting is set to “None”, this setting cannot 
be selected.

*3

If the “Speakers Type (Front)” setting is set to “Bi-Amp”, or 
the “Powered Zone 2” setting is set to “Yes” together with 
Zone 2 turned on, this setting cannot be selected.

*4

If anything else than “None” is selected in “Front High”, this 
setting is automatically set to “None”.

*5

If anything else than “None” is selected in “Surround Back”, 
this setting is automatically set to “None”.

■

`

1ch:

Select if only one surround back speaker L is 
connected.

`

2ch:

Select if two (left and right) surround back speakers 
are connected.

• If the “Surround Back” setting is set to “None”, this setting 

cannot be selected.

• If the “Powered Zone 2” setting is set to “Yes” and Zone 2 is 

turned on, this setting cannot be selected.

Some of the settings in this section are set automatically 
by Audyssey 2EQ

®

 Room Correction and Speaker Setup 

(

“Setup”

This setting is set automatically by Audyssey 2EQ Room 
Correction and Speaker Setup (