ONKYO HT-RC360 사용자 설명서

En

■

`

On 

`

This preference determines whether operation details are 
displayed on-screen when an AV receiver function is 
adjusted.
Even when “On” is selected, operation details may not be 
output if the input source is connected to an HDMI IN.

■

`

English, Deutsch, Français, Español, Italiano, 
Nederlands, Svenska

`

English, Deutsch, Français, Español, Italiano, 
Nederlands, Svenska, 

中文

This setting determines the language used for the on-
screen setup menus.

■

`

1, 2, or 3

When several Onkyo components are used in the same 
room, their remote ID codes may overlap. To differentiate 
the AV receiver from the other components, you can 
change its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

For AM/FM tuning to work properly, you must specify the 
AM/FM frequency step used in your area. Note that when 
this setting is changed, all radio presets will be deleted.

■

`

`

Select the frequency step according to your area.

■

`

`

Select the frequency step according to your area.

■

`

`

Turn this setting on to allow 

p

-compatible 

components connected via HDMI to be controlled by the 
AV receiver (

• When the setting is set to “On” and the menu is closed, the 

names of connected 

p-compatible components and 

“RIHD On” are displayed on the AV receiver.
“Search…” 

→ “(name)” → “RIHD On”

When the AV receiver cannot receive the name of the 
component, it is displayed as “Player

” or “Recorder

”, etc (“

” 

shows up and indicates the number of components, when two or 
more are received).

• When  an 

p-compatible component is connected to the 

AV receiver via an HDMI cable, the name of the connected 
component is displayed on the AV receiver display. For 
example, while you are watching TV broadcasting, if you 
operate a Blu-ray Disc/DVD player (being powered on) with the 
remote control of the AV receiver, the name of the Blu-ray 
Disc/DVD player will be displayed on the AV receiver.

• Set  it  to 

“

”

 when a connected piece of equipment is not 

compatible or it is unclear whether the equipment is compatible 
or not.

• If operation is not normal when set to 

“

”

, change the setting 

to 

“

”

.

• Refer to the connected component’s instruction manual for 

details.

• When  “HDMI Control (RIHD)” setting is set to “On”, the 

power consumption on standby mode slightly increases. 
(Depending on the TV status, the AV receiver will enter standby 
mode as usual.)

page 40).

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.