Texas Instruments TPA6101A2 데이터 시트

2-4

Follow these steps to use the TPA6101A2 EVM stand-alone or when connect-
ing it into existing circuits or equipment. Connections to the TPA6101A2 mod-
ule header pins can be made via individual sockets, wire-wrapping, or solder-
ing to the pins, either on the top or the bottom of the module circuit board.
Numbered callouts for selected steps are shown in Figure 2–2.

Quick Start Module Map

6

2

4

4

5

6

† Due to the very small size of the MSOP IC package, the standard part number TPA6101A2 is

replaced with the code TIAJM.

-

1) Ensure that all external power sources are set to OFF.

2) Connect an external regulated power supply set between 1.6 V and 3.3 V

to the module VDD and GND pins taking care to observe marked polarity.

-

3) Ensure that signal source level is set to minimum.

4) Connect the shutdown pin to V

DD

 through a normally open switch.

5) Connect 32-

Ω

 headphones to the module V

O

1 and V

O

2 pins through

33-

µ

F to 1000-

µ

F output-coupling capacitors (see Figure 3 – 8) and return

to the GND pin, or

6) For line output, connections to the V

O

1 and V

O

2 pins must be made

through 33-

µ

F to 1000-

µ

F output-coupling capacitors and returned to

GND.

-

7) Verify correct voltage and input polarity and set the external power supply

to ON.

The EVM should begin operation.