Texas Instruments SLAU081 사용자 설명서
Shipping (Default Configuration)
2-3
Getting Started
Table 2–1. Default Switch Settings
Switch Settings
Default
Configuration
Description
SW1-1
On
Stand-alone mode is selected, LED is on
SW1-2
Off
Reserved
SW1-3
Off
Reserved
SW1-4
Off
Reserved
Table 2–2. Default Jumper Settings
Jumper Settings
Default Configuration
Description
Pins 1–2
Pins 2–3
W1
Inserted
Not inserted
Input for channel 0 is via BNC connector J1.
W2
Not inserted
Inserted
Sine wave test signal is selected for channel 0.
W3
Not inserted
Inserted
Sine wave test signal is output for channel 0.
W4
Not inserted
Inserted
Onboard conditioned input for channel 0 is selected.
W5
Not populated
Not populated
W6
Not populated
Not populated
W7
Not populated
Not populated
W8
Not populated
Not populated
W9
Not inserted
Disables onboard sine and triangle wave generator
W10
Inserted
Not inserted
SCLK routed to ADC
W11
Not inserted
Inserted
Signal conditioning output selected for channel 0
W12
Inserted
Not inserted
FS routed to ADC
W13
Not Inserted
5-V analog
W14
Inserted
EVM reference or DAC’s on-chip reference selected.
W15
Not populated
Not populated
W16
Inserted
Not inserted
Selects internal or external reference
W17
Inserted
Not inserted
Determines EVM reference voltage
W18
Not inserted
Inserted
FS routed to DAC
W19
Inserted
Not inserted
Selects source of signal conditioning output from DAC
W20
Not inserted
W21
Inserted
Not inserted
These jumpers determine various options for supplying system
W22
Inserted
Not inserted
These jumpers determine various options for supplying system
clock. This has been designed to be as flexible as possible to
clock. This has been designed to be as flexible as possible to
W23
Inserted
Not inserted
clock. This has been designed to be as flexible as ossible to
accommodate many potential options.
accommodate many potential options.
W24
Not inserted
W25
Not populated
Not populated
The hardware that can be reconfigured falls into one of the following sections:
-
Jumpers
-
Switches
-
Connectors