Russound CAV6.6 사용자 설명서

18

Unpacking the Components
• Keep the original carton and packing materials
for future shipment or storage. 

• Check for any visible signs of damage. If
you encounter any concealed damage, con-
sult your Russound dealer before proceeding
to install the unit.

• Retain the sales receipt as it establishes the
duration of the limited warranty and provides
information for insurance purposes.

• Drill with a 1/2” x 6” drill bit

• Keyhole saw

• Flat head screwdriver (medium size) 

• Phillips Screwdriver (cordless recommended) 

• 110 punchdown tool (included)

• Modular RJ-45 crimper and connectors

• Pair of diagonal cutters or wire strippers

• Stud finder

• Steel wire fish tape

• Cable staples 

• PLASTIC double-gang electrical work boxes 

System Installation Considerations
There are several factors to consider before
installing the Russound CAV6.6 controller:

• What are the intended listening zones, and
what zones require audio and video distribution
or audio only? 

• Are A-BUS

®

sub-zones needed? A-BUS sub-

zones are only available for zones 1 - 4. The 
A-KP2 amplified keypad can provide direct
source selection for only the first four sources
when in ‘Multi’ source mode. 

• What system options and accessories might
be required for features such as paging, local
sources, etc.?

• From where in each zone will the user prefer
to control the system? Where will the keypads
be located? Where will the speakers be located?  

• Where will the source equipment be located?
The CAV6.6 must have proper ventilation above
and below for air circulation and heat dissipation.
A rack-mount location may require fans and vents.

Connection Tips
• It is recommended that the CAV6.6 and the
source equipment be plugged into a dedicated
20-amp circuit with an isolated ground. A power
line conditioner can reduce interference prob-
lems caused by noise found in some electrical
systems.

• Disconnect all live power cords before making
connections to the controller.

• Verify that all connections and polarity are
correct.

• Keep all power cords away from all signal
cables to prevent humming from induced noise.

• Choose reliable signal cables/patch cords.

• Label all wires with room location at both ends
of the wire.

Do not connect the controller's main power feed until all other connections have
been made and verified. Live connection or removal of the keypad wiring or other
wiring when the system is powered can cause communication problems in the
network.  Double-check terminations during each phase of the installation to pre-
vent accidental damage. Incorrect wiring is the number one cause for non-war-
ranty product damage.