Radio Shack XL-150 사용자 설명서
14
CONNECTING
SPEAKERS
SPEAKERS
You can connect two or four speakers
to the amplifier and your autosound
system.
to the amplifier and your autosound
system.
Preparing the Speaker Wires
Caution: You must connect a sepa-
rate wire to each speaker terminal as
described in the following procedures.
Only use a common ground wire or
chassis ground if your autosound sys-
tem is wired for it.
rate wire to each speaker terminal as
described in the following procedures.
Only use a common ground wire or
chassis ground if your autosound sys-
tem is wired for it.
Notes:
• We recommend you use 16- or 18-
gauge marked or color-coded
wires to help you correctly connect
the speakers to your amplifier.
wires to help you correctly connect
the speakers to your amplifier.
• Color-coded wires have a stripe
running down one of the conduc-
tors or different colored insulation
for each conductor. Your local
RadioShack store has a wide
selection of speaker wire to
choose from.
tors or different colored insulation
for each conductor. Your local
RadioShack store has a wide
selection of speaker wire to
choose from.
• For the maximum bass response
and the best overall performance,
keep your speakers properly
phased (connect + to + and – to –).
keep your speakers properly
phased (connect + to + and – to –).
1. With the speakers placed in their
approximate locations, run one
wire from each speaker to the
amplifier.
wire from each speaker to the
amplifier.
If you are connecting a subwoofer,
run two wires from each of the
subwoofer’s terminals to the
amplifier.
run two wires from each of the
subwoofer’s terminals to the
amplifier.
2. Separate each wire’s two conduc-
tors at both ends for a length of
about 4 inches.
about 4 inches.
3. Strip the insulation from the ends
of each conductor to expose
1
/
4
inch of wire. Twist the ends to
secure loose strands.
secure loose strands.
Wire Strands
Conductors
12-2015.fm Page 14 Tuesday, July 13, 1999 3:47 PM