MRV Communications EM316EDFA-LPR 사용자 설명서

 

 

®

 

 
P/N 1294008-001 Rev D2 

 

5 

 
 

 
EM316xx cards are hot-swappable in a powered Fiber Driver chassis. Install the EM316xx module 
by aligning the edge of the card with the rail of the chassis slot. Hand-tighten the thumb screw. Do 
not over-tighten. 
 
The thumb screw is on the left when installed in the BU-1, BU-2, BU-3, and BU-4 chassis. The 
thumb screw is on the bottom when installed in the BU-16 chassis. 
 

 

•  6-inch Phillips #1 screwdriver (for some module screws) 

•  6-inch flat-tip 5.0 screwdriver 

 
 

 
Follow all guidelines to eliminate static electricity while handling the module and other electronic 
devices. Refer to the front of this manual for some safety suggestions. 
 
 
 
Step 1

 Remove the blank panel or old module from the target chassis slot. Unfasten the 

mounting screws with a 6-inch Phillips screwdriver, or disengage any thumb screws by hand. 
 

 

Figure 4   -- Remove the required blank panels 

 
 
To comply with FCC regulations and for optimal cooling air flow, a cover panel or a module must 
cover every chassis slot. To limit external signals, no chassis slot should remain open when the 
unit is operational. Secure modules and panels with appropriate screws for grounding and 
further compliance.