MRV Communications EM316EDFA-LPR 사용자 설명서

 

 

®

 

 
P/N 1294008-001 Rev D2 

 

v 

 

 
 

 

 
Disconnect all power from electronic devices before servicing. Some equipment may have 
multiple power cords requiring disconnection. 
 
 

 

 

WARNING: Fiber optic equipment may emit laser or infrared light that can injure your 
eyes. Never look into an optical fiber or connector port. Always assume that fiber optic 
cables are connected to a laser light source. 

 

CAUTION: Do not install or terminate fibers when a laser may be active. 

 

WARNING: Never look directly into a live optical fiber. Always wear appropriate laser 
safety glasses when working with open fiber cables that might be connected to an 
operational laser transmitter. Direct open fibers ends away from faces. 

 

CAUTION: Use of controls or adjustments or performing procedures other than those 
specified herein may result in hazardous radiation exposure. 

 
If a fiber optic laser device output is recognized as a higher than Class 1 product (Class 1M, for 
example), the device is evaluated, labeled, and certified by TUV. Class 1 and 1M outputs are 
not considered hazardous, but laser safety practices should always be observed. 
 

 

 
A fiber optic transceiver emits either single-mode or multi-mode light into a fiber optic strand. 
Take the following precautions when handling optical fibers. 
 

•  Wear safety glasses when you install optical fibers. 

•  Be aware of the risk of laser radiation exposure. 

•  Always assume that fiber optic cables are active because transmitted light is invisible to 

the human eye. 

•  Never look directly into a beam (T

X

 part of a transmitter) or open fiber ends. The invisible 

light can damage your eyes. 

•  Place optical fibers in a safe location during installation. 

•  Protect optical fiber connectors with clean dust caps for safety and sanitation. 

•  Follow the manufacturer instructions when using optical test equipment.