Dual XIA4225 사용자 설명서
11
XIA4225
OPERATION
Troubleshooting
Problem
Cause
Action
Unit will not turn on
(no power LED indicator)
+12V wire not connected or incorrect voltage
REM wire not connected or incorrect voltage
REM wire not connected or incorrect voltage
Check connections for proper voltage
(11~16VDC)
(11~16VDC)
GND wire not connected
Check connection to ground
Fuse(s) blown
Replace fuse(s)
Unit has power - LED is
green (but no sound)
Speaker wires not connected
Check connections at speakers
Volume turned all the way down
Increase volume level at head unit
One or more speaker wires touching each
other or touching chassis ground
other or touching chassis ground
Insulate all bare speaker wires from
each other and chassis ground
each other and chassis ground
Speaker(s) defective or damaged
Check/replace speaker(s)
Input signal not connected
Check high or low level inputs for
proper connection
proper connection
Unit blows fuse(s)
Incorrect fuse rating
Use fuse(s) with correct rating
+12V wire touching chassis ground
Check for pinched wire
Speaker(s) defective or damaged
Check/replace speaker(s)
Engine noise
Bad ground connection
Make sure amplifier is grounded to
clean bare metal
clean bare metal
Signal ground loop or RFI
(radio frequency interference)
(radio frequency interference)
Re-route RCA cables from existing
high current wiring
high current wiring
LED illuminates red
(protect mode)
One or more speaker wires touching each
other or touching chassis ground
other or touching chassis ground
Insulate all bare speaker wires from
each other and chassis ground
each other and chassis ground
Speaker(s) defective or damaged internally
(shorted)
(shorted)
Check/replace speaker(s)
Speaker load less than 2 ohms (stereo)
Speaker load less than 4 ohms (bridged)
Speaker load less than 4 ohms (bridged)
Adjust speaker load - amplifier will
not operate at less than 4 ohms when
bridged
not operate at less than 4 ohms when
bridged
Distorted audio output
Incorrect input signal type or input level too
high
high
Check connections and reduce/adjust
input level
input level
Low audio output
Incorrect input signal type or input level
too low
too low
Check connections and increase/
adjust input level
adjust input level
Weak bass
Speaker(s) are wired out of phase
Check (+) and (-) speaker connections
(Observe correct polarity)
(Observe correct polarity)
No illuminite output
(no lights)
Fuse blown - illuminite output (+12VDC) wire
touching ground
touching ground
Check or replace fuse
Use 2 amp ATO fuse only
Use 2 amp ATO fuse only
illuminite (+) or (-) wires not connected
Check connections at speakers
illuminite connections wired wrong
(reverse polarity)
(reverse polarity)
Reverse (+) and (-) connections
(Observe correct polarity)
(Observe correct polarity)
illuminite speaker(s) defective or damaged
Check/replace speaker(s)