Lucent Technologies 585-210-940 사용자 설명서

2

Now you will complete the installation of the usual software by installing 
CMS. In general, the steps are as listed below. Detailed installation 
instructions can be found in 

CentreVu CMS R3V8 Software Installation 

and Setup (585-210-941).

The steps to be completed are these:

●

Install CMS software

●

Install CMS patches (if needed)

●

Install CMS Supplemental Services software

●

Set up CMS

●

Install Open Database Connectivity (ODBC) software (optional)

●

Set up the remote console

●

Administer the NTS (if using NTS ports)

2

1. Enter the following command:

where 

newbootdev is the device name of the disk chosen as boot 

disk 2 (as c0t1d0s0, for example). You partitioned that disk earlier in 
the installation procedure.

The system responds (for example):

2. Record the device definition (the part after 

/devices

 and 

before

:a,raw). 

For the example above, you would record the part 

beginning 

/sbus@3,0 

and ending

 sd@1,0

.

3. Reboot the system by entering the following command:

The system displays the

 ok 

prompt.

4. Create a device alias for the new boot device by entering the 

following command (for example):

Replace 

<device> 

with what you recorded in item 2. For the 

example shown, you would replace 

<device> with the following:

/sbus@3,0/SUNW,fas@3,8800000/sd@2,0

#

ls

-l

/dev/rdsk/

newbootdev

lrwxrwxrwx   1 root     root          83 Jun 18 15:23 

/dev/rdsk/c0t1d0s0 -> ../../devices/sbus@3,0/SUNW,

fas@3,8800000/sd@1,0:a,raw

#

/usr/sbin/shutdown

-y

-i0

-g0

ok nvalias

bootdevice2

<device>