JVC SP-DWF10 사용자 설명서

– 3 –

Press  the AUTO POWER ON/STANDBY switch to the [  ] ON
position.
• If no sound comes in for 5-10 minutes, the unit enters
    standby mode. The power lamp lights in red.
• If the unit detects incoming signals, the unit starts
    operating. The power lamp  lights in green.

To cancel AUTO POWER ON/STANDBY.
Press  out the AUTO POWER ON/STANDBY switch to set it to the

[  ] CANCEL position.

  

CANCEL

ON

AUTO POWER ON / STANDBY

When the volume level of the amplifier is so low or the
incoming signals are so weak that this unit cannot detect
sounds, Auto Power On/Standby may not work correctly.

To turn on the power.
Press the POWER switch to the [ 

❙ ] ON position.

• The power lamp lights in green.

To cut of the power.
Press the POWER switch to the [ 

‡ ] OFF position.

• The power lamp goes out.
• This will disconnect the mains lead.

Power lamp

Before connecting this unit to the amplifier (or receiver), observe
the following carefully.
• Turn off the amplifier.
• Make all connections before plugging in this unit.

• DO NOT connect this unit to the REC OUT jacks of your

amplifier. It may damage your subwoofer.

To LINE OUT

To SUBWOOFER OUT
or MONO

Stereo audio cord (not Supplied)

In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal.

Monaural audio cord (Supplied)

To an AC outlet

SP-DWF10_Eng.pm65

4/27/04, 9:24 AM

3