Sony STRDH820 사용자 설명서

D:\NORM'S JOB\SONY HA\SO0129\STR-DH820_PMRF_01\4266497112_GB\GB07ADD_STR-
DH820-CEL.fm

STR-DH820

4-266-497-11(2)

• Place the receiver in a location with adequate 

ventilation to prevent heat buildup and 
prolong the life of the receiver.

• Do not place the receiver near heat sources, 

or in a place subject to direct sunlight, 
excessive dust, or mechanical shock.

• Do not place anything on top of the cabinet 

that might block the ventilation holes and 
cause malfunctions.

• Do not place the receiver near equipment 

such as a TV, VCR, or tape deck. (If the 
receiver is being used in combination with a 
TV, VCR, or tape deck, and is placed too 
close to that equipment, noise may result, 
and picture quality may suffer. This is 
especially likely when using an indoor 
antenna (aerial). Therefore, we recommend 
using an outdoor antenna (aerial).)

• Use caution when placing the receiver on 

surfaces that have been specially treated 
(with wax, oil, polish, etc.) as staining or 
discoloration of the surface may result.

Before connecting other equipment, be sure to 
turn off and unplug the receiver.

Clean the cabinet, panel, and controls with a 
soft cloth slightly moistened with a mild 
detergent solution. Do not use any type of 
abrasive pad, scouring powder, or solvent, 
such as alcohol or benzine.

If you have any questions or problems 
concerning your receiver, please consult your 
nearest Sony dealer.

If you experience any of the following 
difficulties while using the receiver, use this 
troubleshooting guide to help you remedy the 
problem. Should any problem persist, consult 
your nearest Sony dealer. Note that if service 
personnel changes some parts during repair, 
these parts may be retained.

• “Auto Standby” is set to “ON” (page 74).
• The Sleep Timer function is working 

• Check that the DVD, etc. you are playing 

is recorded in Dolby Digital or DTS 
format.

• When connecting the DVD player, etc., to 

the digital input jacks of this receiver, 
make sure the digital audio output setting 
of the connected equipment is available.

• Set “Audio Out” to “AMP” in the HDMI 

Settings menu. 

• Make sure you have selected the sound 

field for movie or music (page 54 or 55).

• Sound fields do not function when 

 

DTS-HD Master Audio, DTS-HD High 
Resolution Audio or Dolby TrueHD with 
sampling frequency of more than 48 kHz 
are being received.