Sony DA6400ES 사용자 설명서

To save the measurement results obtained in 
“Performing auto calibration” (page 49), 
proceed with the following steps.

B/b to select “Yes” in 

The selecting screen of the calibration 
type appears.

V/v repeatedly to select 

The measurement results are saved.

b.

The exit screen appears.

• After reflecting the results of a compensation for a 

frequency characteristic, signals with a sampling 
frequency of higher than 96 kHz are always played 
back at either 44.1 kHz or 48 kHz.

• The frequency response measurement result is not 

utilized in the following cases.
– The multi-channel input is selected.
– “2ch Analog Direct” is being used.

• The measurement result is not utilized when Dolby 

TrueHD signals with a sampling frequency of 
higher than 96 kHz are being received.

The size of a speaker (LARGE/SMALL) is 
determined by the low characteristics. The 
measurement results may vary, depending on the 
position of the optimizer microphone and speakers, 
and the shape of the room. It is recommended that 
you follow the measurement results. However, you 
can change those settings in the Speaker settings 
menu. Save the measurement results first, then try to 
change the settings if you want.

Full Flat

Makes the measurement of 
frequency from each 
speaker flat.

Engineer

Sets the frequency to one 
that matches that of the 
Sony listening room 
standard.

Front Reference Adjusts the characteristics 

of all the speakers to match 
the characteristics of the 
front speaker.

OFF

Sets the auto calibration EQ 
to off.