Sony DAV-DZ120 사용자 설명서

face the calibration mic, and there should be 
no obstruction between the speakers and the 
calibration mic. Be quiet during the 
measurement.

X/x to select [YES], then press 

Calibration starts.

• Avoid being in the measurement area and 

making noise during the measurement (about 3 
minutes), to avoid measurement failure. During 
the measurement, test signals are output from 
the speakers.

• Reflections from walls or the floor may affect 

measurements.

• If an error message appears, follow the message, 

then select [YES].
An error message appears when:

–the headphones are connected.

–the calibration mic is not connected.

–front speakers are not correctly connected.

–surround speakers are not correctly connected.

–front and surround speakers are not correctly 

connected.

–there is excessive noise around the calibration 

mic.

–the calibration mic is overloaded.

C/X/x/c to select [YES] or [NO], 

x The measurement is OK.

Disconnect the calibration mic, then select 
[YES]. The result is implemented.

x The measurement is not OK.

Follow the message, then select [YES] to 
retry.

• You can check the distance between the listening 

position and each speaker. See page 71.

• While the Auto Calibration function works:

– do not turn off the power.

– do not press any button.

– do not change the volume.

– do not change the function.

A.CAL MIC

Calibration mic

Measuring. Please wait a moment.

FRONT L :
FRONT R :
CENTER  :
SUBWOOFER :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
YES.

YES

YES
YES
NONE
YES
NONE
NONE

Measurement complete.

NO

Check speaker connection.
Retry?

YES

Measurement failure.

NO