Sony DHC-MD313 사용자 설명서
46
Labelling the preset stations
(continued)
(continued)
4
Press ENTER/YES.
The cursor starts flashing.
5
Press CHARACTER repeatedly
until the type of character you want
appears.
until the type of character you want
appears.
Each time you press the button, the
display changes as follow:
A (Upper case) n a (Lower case) n 0
(Numbers) n ! (Symbols)* n
display changes as follow:
A (Upper case) n a (Lower case) n 0
(Numbers) n ! (Symbols)* n
(Space)
n
A…
* You can use the following symbols.
6
Press +/– repeatedly until the
desired character appears.
desired character appears.
To enter a blank space, skip this step.
7
Press CURSOR /.
The character you selected in step 6 stops
flashing and the cursor shifts to the right.
flashing and the cursor shifts to the right.
!"#$%&'()
∗
+,–./:;<=>?@_`
8
Repeat steps 5 through 7 to
complete the entire title.
complete the entire title.
If you enter an incorrect character, press
CURSOR ? or / until the character
you want to change flashes, then repeat
steps 5 through 7. To erase a character,
press CANCEL/NO while the character
is flashing.
CURSOR ? or / until the character
you want to change flashes, then repeat
steps 5 through 7. To erase a character,
press CANCEL/NO while the character
is flashing.
9
Press ENTER/YES to complete the
labelling procedure.
labelling procedure.
To cancel labelling
Press EDIT.
To check the titles
Press DISPLAY.
Each time you press the button, the display
changes as follows:
changes as follows:
The station name ˜ Frequency
To erase the name
Start over from steps 1 through 5 and press
CANCEL/NO repeatedly until the label
disappears.
CANCEL/NO repeatedly until the label
disappears.
LEVEL SYNC
-
DBFB
PRESET
J
1
Cursor
LEVEL SYNC
-
DBFB
1
PRESET
Cursor