Sony DHC-MD313 사용자 설명서

Step 3: Presetting radio stations
(continued)

Press ENTER/YES on the remote.

Press +/– on the remote to select the
preset number you want.

Press ENTER/YES on the remote.

The station is stored.

Repeat steps 1 through 7 to preset
other stations.

To tune in a station with a weak
signal

Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
TUNING +/– to tune in the station and
continue from step 4.

To change the preset number

Start again from step 1.

To change the AM/MW tuning
interval (except for European
model)

The AM/MW tuning interval is factory-set to
9 kHz (10 kHz in some areas). To change the
AM/MW tuning interval, tune in any AM/
MW station first, then turn off the power.
While holding down the FUNCTION button,
turn the power back on. When you change
the interval, all the AM/MW preset stations
are erased. To reset the interval, repeat the
same procedure.

The preset number

Tips

• The preset stations are retained for a day even if

you disconnect the mains lead or if a power failure
occurs.

• You can create titles for the preset stations (see

page 45).

• To improve broadcast reception, reorient the

supplied aerials or connect the optional external
aerial.

• When an FM programme has static noise,

press STEREO/ MONO until “MONO” appears.
There will be no stereo effect, but the reception
will improve. Press the button again to restore the
stereo effect.

LEVEL SYNC

DBFB

TUNED