Sony LBT-ZTX7 사용자 설명서
47
GB
Ad
ditional Inf
ditional Inf
o
rmation
* This system supports FAT16 and FAT32, but
some USB device may not support all of these
FAT. For details, see the operating
instructions of each USB device or contact the
manufacturer.
FAT. For details, see the operating
instructions of each USB device or contact the
manufacturer.
Tuner
There is severe hum or noise.
(“TUNED” or “ST” flashes in the
display)
(“TUNED” or “ST” flashes in the
display)
• Set the proper band and frequency
• Connect the antenna properly (page 12).
• Find a place and an orientation that
• Find a place and an orientation that
provide good reception, then set up the
antenna again. If you cannot obtain
good reception, we recommend that you
connect a commercially available
external antenna.
antenna again. If you cannot obtain
good reception, we recommend that you
connect a commercially available
external antenna.
• The supplied FM lead antenna receives
signals along its entire length, so make
sure you extend it fully.
sure you extend it fully.
• Locate the antennas as far away from
the speaker cords as possible.
• Try turning off the surrounding
electrical equipment.
A stereo FM program cannot be
received in stereo.
received in stereo.
• Press FM MODE on the remote
repeatedly until “MONO” disappears
from the display.
from the display.
Tape deck
The tape does not record or playback,
or there is a decrease in sound level.
or there is a decrease in sound level.
• The tape heads are dirty (see “Cleaning
• The record/playback heads are
The tape does not erase completely.
• The record/playback heads are
There is excessive wow or flutter, or
the sound drops out.
the sound drops out.
• The capstans or pinch rollers are dirty
Noise increases or the high
frequencies are erased.
frequencies are erased.
• The record/playback heads are
The tape does not record.
• No tape is loaded. Load a tape.
• The tab has been removed from the tape.
• The tab has been removed from the tape.
Cover the broken tab with adhesive tape
(page 51).
(page 51).
• The tape has reeled to the end.
The system cannot play back the
reverse side of the tape in tape deck.
reverse side of the tape in tape deck.
• The system only can play back front
side of the tape in tape deck. This is not
a malfunction.
a malfunction.
The system cannot record the reverse
side of the tape in tape deck.
side of the tape in tape deck.
• The system only can record front side of
the tape in tape deck. This is not a
malfunction.
malfunction.
The recorded sound has echo effect.
• Before you start recording, press
FLANGER, DELAY or CHORUS
repeatedly until “FLANGER”,
“DELAY” and “CHORUS” disappear
from the display.
repeatedly until “FLANGER”,
“DELAY” and “CHORUS” disappear
from the display.
Continued
l