Sony DTC-ZE700 사용자 설명서

19

The following table explains the various messages that
appear in the display.

A safety mechanism is operating because of
condensation or other reasons.

BLANK

The deck is searching for the beginning of the
blank section on the tape.

CAUTION

Cleaning the head and tape path is
recommended.  After about 10 hours of deck
use, this message appears for about 10
seconds whenever you turn on the deck .

CLEANING

A cassette  is not inserted into the deck.

A start ID or program number is being
written.

The deck is searching for the beginning of the
start ID to be erased.

A start ID is being erased.

ID WRITE

ID ERASE

(ERASE)

NO TAPE

WAIT

(WRITE)

This appears when the START ID WRITE
button is pressed.

The program source you are about to record
cannot be recorded through the digital input
jacks or connectors.  For more information,
see “Guide to the Serial Copy Management
System” (see pages 22 and 23).

The deck has been in recording pause for
about 10 minutes, or you've pressed the
r REC button while no cassette is in the deck
or the cassette is record-protected.

No digital signal is being input to the jack or
connector that you selected with the INPUT
switch.

The deck is searching for the beginning of the
blank section on the tape.

UNLOCK

TAPE END

SOURCE

PROTECT

PROHIBIT

REHRSL

TAPE TOP

The record-protect hole on the cassette is
open and recording on the tape cannot be
done.

The tape has come to the end of the recorded
portion.

The tape has reached its beginning.

Rehearsal is on.

Do not use thin-tape cassettes (with a playing time of over
120 minutes) to record important material since such
cassettes are subject to the following problems:

— Improper threading of the tape after repeated AMS,

rewinding, fast-forwarding, or cueing operations.

— Incorrect writing and erasing of start IDs.
— Sound distortion.

If you have any questions or problems concerning your
unit, please consult your nearest Sony dealer.

Use a soft cloth slightly moistened with a mild
detergent solution.  Do not use any type of abrasive
pad, scouring powder or solvent such as alcohol or
benzine.

• Prolonged operation will cause contamination of the

head.  To obtain the best possible recording and
playback sound, we recommend that you use the
Sony DT-10CL cleaning cassette (not supplied) to
clean the head after every ten hours or so of
operation.

• Clean the head with the cleaning cassette when the

deck has not been used for a long period of time.
Contamination of the head may cause sound drop-
out during playback.

1 Insert the cleaning cassette as you would a normal DAT

cassette.

2 Press 

·.  After 10 seconds, press p.

Do not press the 

r REC or ) button for cleaning.

3 Remove the cleaning cassette without rewinding it.  You

should rewind the cleaning cassette only when it has
reached the end.

• After 10 hours of operation, “CLEANING” appears in the

display for about ten seconds when you turn on the deck.
It is recommended that you clean the head and tape path
periodically, using this message as a guide.

• Due to the shortness of the cleaning cassette, the counter

will not show the actual running time and remaining time
of the cassette.