Sony HT-DDW900 사용자 설명서
71
US
E:\SEM_soowan(film)\J9050000_2662263112DDW900_US\2662263112\US05AMP_HT-
DDW900-U.fm
DDW900-U.fm
masterpage: Right
HT-DDW900
2-662-263-11 (2)
Ad
dition
dition
al I
n
n
fo
rm
atio
n
Specifications
AUDIO POWER
SPECIFICATIONS
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
HARMONIC DISTORTION:
(Models of area code U only)
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.7% total harmonic distortion from 250
milliwatts to rated output.
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.7% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
1)
Models of area code U, CA
(6 ohms 1 kHz, THD 0.7%)
FRONT
(6 ohms 1 kHz, THD 0.7%)
FRONT
2)
: 90
W/ch
CENTER
2)
: 90
W
SUR
2)
: 90
W/ch
(6 ohms 1 kHz, THD 10%)
FRONT
FRONT
2)
: 140
W/ch
CENTER
2)
: 140
W
SUR
2)
: 140
W/ch
1)
Measured under the following conditions:
2)
Depending on the sound field settings and the
source, there may be no sound output.
source, there may be no sound output.
Inputs (Analog)
Inputs (Digital)
Outputs (Analog)
Reproduction frequency range
28 - 20,000 Hz
Tone
FM tuner section
Tuning range
87.5 - 108.0 MHz
Antenna
FM wire antenna
Antenna terminals
75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
Models of area code U, CA
Models of area code U, CA
With 10-kHz tuning scale:
530 – 1,710 kHz
3)
With 9-kHz tuning scale:
531 – 1,710 kHz
3)
Antenna
Loop antenna
Intermediate frequency
450 kHz
3)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
Video section
Inputs/Outputs
Video:
1 Vp-p, 75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P
P
B
/C
B
/B-Y: 0.7 Vp-p,
75 ohms
P
P
R
/C
R
/R-Y: 0.7 Vp-p,
75 ohms
80 MHz HD Pass Through
80 MHz HD Pass Through
Area code
Power requirements
U, CA
120 V AC, 60 Hz
MULTI CH IN,
SA-CD/CD,
MD/TAPE, DVD,
VIDEO 1, 2, 3
VIDEO 1, 2, 3
Sensitivity: 800 mV
Impedance: 50 kohms
DVD (Coaxial)
Sensitivity: –
Impedance: 75 ohms
VIDEO 1, 2
(Optical)
(Optical)
Sensitivity: –
Impedance: –
MD/TAPE (OUT),
VIDEO 1 (AUDIO
OUT)
VIDEO 1 (AUDIO
OUT)
Voltage: 800 mV
Impedance: 10 kohms
SUB WOOFER
Voltage: 2 V
Impedance: 1 kohm
Gain levels
±6 dB, 1 dB step
continued
US01COV_HT-DDW900-U.book Page 71 Thursday, December 15, 2005 4:08 PM