Sony HT-DDW750 매뉴얼
Operations Using the Remote RM-PP412
HT-DDW750 4-244-183-11(1) GB
41
GB
The numeric codes corresponding to
the component and the maker of the
component
Use the numeric codes in the tables below to
control non-Sony components and also Sony
components that the remote is normally unable
to control. Since the remote signal that a
component accepts differs depending on the
model and year of the component, more than
one numeric code may be assigned to a
component. If you fail to program your remote
using one of the codes, try using other codes.
control non-Sony components and also Sony
components that the remote is normally unable
to control. Since the remote signal that a
component accepts differs depending on the
model and year of the component, more than
one numeric code may be assigned to a
component. If you fail to program your remote
using one of the codes, try using other codes.
Notes
• The numeric codes are based on the latest
information available for each brand. There is a
chance, however, that your component will not
respond to some or all of the codes.
chance, however, that your component will not
respond to some or all of the codes.
• All of the input selectors on this remote may not be
available when used with your particular
component.
component.
To control a CD player
Maker
Code(s)
SONY
101, 102, 103
DENON
104, 123
JVC
105, 106, 107
KENWOOD
108, 109, 110
MAGNAVOX
111, 116
MARANTZ
116
ONKYO
112, 113, 114
PANASONIC
115
PHILIPS
116
PIONEER
117
TECHNICS
115, 118, 119
YAMAHA
120, 121, 122
continued
5
Repeat steps 1 to 4 to control other
components.
components.
To cancel programming
Press USE MODE during any step. The remote
automatically exits the programming mode.
automatically exits the programming mode.
To activate the input source after
programming
Press the programmed button to activate the
input source you want.
input source you want.
If programming is unsuccessful,
check the following:
• If the indicator does not light up in step 1, the
batteries are weak. Replace both batteries.
• If the indicator flashes 4 times in quick succession
while entering the numeric code, an error has
occurred. Start again from step 1.
occurred. Start again from step 1.
Notes
• The indicator turns off while a valid button is
pressed.
• In step 2, if several input selector buttons are
pressed, only the last pressed button is valid.
• In step 2, if you press TV ?/1, only TV VOL +/–,
TV CH +/–, TV/VIDEO and WIDE buttons are
reprogrammed.
reprogrammed.
• In step 3, if an input selector button is pressed, the
new input source is selected and the programming
procedure returns to the beginning of step 3.
procedure returns to the beginning of step 3.
• For the numeric codes, only the first three numbers
entered are valid.
To clear the memory of the remote
To clear all programmed and learned signals,
do the following to reset the remote to factory
settings.
do the following to reset the remote to factory
settings.
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
the same time.
The indicator flashes 3 times, then goes off.
01GB09REMCA.p65
11/29/02, 2:22 PM
41