Sony HTSS380 사용자 설명서
27
US
Pr
ep
a
ep
a
ri
n
g
th
e
e
re
c
c
e
iv
er
When error codes appear
1
Check the problem of the error.
*
xxx
represent a speaker channel
F
Front
S
Surround
SW
Subwoofer
Depending on the error code, the speaker
channel may not appears.
channel may not appears.
2
Perform Auto Calibration again.
Press
Press
V/v to select “RETRY YES”, then
press .
3
If a warning on the measurement result is
present, detailed information is displayed.
present, detailed information is displayed.
*
xxx
represent a speaker channel
FL
Front left
FR
Front right
CNT
Center
SL
Surround left
SR
Surround right
SW
Subwoofer
Depending on the measurement result, the speaker
channel may not appears.
channel may not appears.
To return to step 2 of
“3: Confirming/saving the
measurement results”
measurement results”
Press .
Tip
Depending on the position of the subwoofer, the
measurement results may vary. However, there will
be no problems even if you continue to use the
receiver with that value.
measurement results may vary. However, there will
be no problems even if you continue to use the
receiver with that value.
Display and explanation
E -
xxx
*
32
None of the speakers were detected. Make sure
that the optimizer microphone is connected
properly and perform the Auto Calibration
again.
If the optimizer microphone is connected
properly but the error code still appears, the
optimizer microphone cable may be damaged.
that the optimizer microphone is connected
properly and perform the Auto Calibration
again.
If the optimizer microphone is connected
properly but the error code still appears, the
optimizer microphone cable may be damaged.
E -
xxx
*
33
• The optimizer microphone is not connected.
• None of the front speakers are connected or
• None of the front speakers are connected or
only one front speaker is connected.
• Either the surround left or surround right
speaker is not connected.
• The subwoofer is not connected.
Checking the warning message
Display and explanation
W -
xxx
* 40
The measurement process has completed with high
noise level detection.
You may be able to achieve better results if you try
in a quite environment again.
noise level detection.
You may be able to achieve better results if you try
in a quite environment again.
W -
xxx
* 41
W -
xxx
* 42
The input from the microphone is too big. The
distance between the speaker and the microphone
may be too close. Set them apart and perform the
measurement again.
distance between the speaker and the microphone
may be too close. Set them apart and perform the
measurement again.
W -
xxx
* 43
The distance and position of a subwoofer cannot be
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
NO WARN
There is no warning information.
There is no warning information.