JVC SP-FSY1 사용자 설명서

Introduction

This page is for when operating your TV using the
remote control of this product.

Setting the manufacturer's code

Slide the remote control mode
selector to the TV side.

Keep pressing down

TV.

NOTE
Keep pressing down

TV until Step

is complete.

Press ENTER.

Press number buttons (1-9, 0).

Ex.:
For a Hitachi TV: Press 0, then 7.
For a Toshiba TV: Press 2, then 9.

If there are more than one manufacturer’s codes,
try them in turn and select the one that causes the
product to work properly.

NOTE
Manufacturer’s codes may be changed without notice.
You may not be able to operate a TV produced by the
manufacturer shown above.

Release TV.

For TV operation

Operate the remote control by pointing it towards
the TV.

*1 Make sure to slide the remote control mode

selector to the TV side in advance.

NOTE
When the batteries are replaced, perform the
manufacturer's code setting again.

Operating the TV using
the remote control

Manufacturer

Code

Manufacturer

Code

JVC

Nordmende

13, 14, 18,

26 – 28

Akai

02, 05

Okano

Blaupunkt

Orion

Daewoo

10, 31, 32

Panasonic

16, 17

Fenner

04, 31, 32

Philips

Fisher

Saba

13, 14, 18,

26 – 28

Grundig

Sanyo

Hitachi

07, 08

Schneider

02, 05

Inno-Hit

Sharp

Irradio

02, 05

Sony

21 – 25

Magnavox

Telefunken

13, 14, 18,

26 – 28

Mitsubishi

11, 33

Thomson

13, 14, 18,

26 – 28, 30

Miver

Toshiba

Nokia

12, 34

Turn ON/OFF the power.

Change channels.

Adjust volume.

Select channels.

Alternates between the
previously selected channel
and the current channel.

Switch TV and video input.

100+

Getting started

FS-Y1[B]_f.book Page 7 Friday, April 15, 2005 7:46 PM