ONKYO DV-C501 사용자 설명서

Installing the remote controller batteries

1. Remove the battery compartment cover by pressing

and sliding it away from the remote controller unit.

2. Insert two AA (R6- or UM-3)-size batteries into the

battery compartment. Carefully follow the polarity
diagram (positive (+) and negative (–) symbols) inside
the battery compartment.

3. After batteries are installed and seated correctly,

replace the compartment cover.

Notes:

• Do not mix new batteries with old batteries or different

kinds of batteries.

• To avoid corrosion, remove the batteries if the remote

controller is not to be used for a long time.

• Remove dead batteries immediately to avoid damage

from corrosion. If the remote controller doesn’t operate
smoothly, replace both the batteries at the same time.

• The life of the batteries supplied is about six months but

this will vary depending on usage.

Using the remote controller

Point the remote controller toward the remote control
sensor.

Notes:

• Place the unit away from strong light such as direct

sunlight or inverted fluorescent light which can prevent
proper operation of the remote controller.

• Using another remote controller of the same type in the

same room or using the unit near equipment which uses
infrared rays may cause operational interference.

• Do not put any object such as a book on the remote

controller. The buttons of the remote controller may be
pressed by mistake and drain the batteries.

• Make sure the audio rack doors do not have colored

glass. Placing the unit behind such doors may prevent
proper remote controller operation.

• If there is any obstacle between the remote controller and

the remote control sensor, the remote controller will not
operate.

Preparing the Remote Controller

DV-C501

STANDBY indicator

Remote control sensor

approx. 5 m

(16 feet)